M54646AP Mitsubishi Electronics America, Inc., M54646AP Datasheet - Page 6

• Manufacturer Part Number: M54646AP
• Description: 2-phase Motor Driver
• Manufacturer: Mitsubishi Electronics America, Inc.

CAUTION
(1) Be sure to short-circuit V
(2) When IC total output current changes greatly, e.g. when output
(3) Excessive power voltage fluctuations may cause unstable IC
(4) Thermal protection function
(5) Flywheel diode
• Thermal protection characteristics may differ depending on
• Circuit boards on which this IC mounted are designed such
current flows intermittently due to thermal protection operation,
supply voltage may fluctuate. Provide power supply and wiring
such that even in such a case amperage will not exceed
absolute maximum rating.
operation. To regulate such fluctuations, connect capacitor
between terminals V
possible. (Refer to application example.)
This IC has built in flywheel diode to provide a return current
route to motor. To prevent overheating and malfunction in
operational areas where great current and voltage are applied,
install a Schottky diode externally. For details, refer to “Area of
Safe Operation” and “Application Example.”
wiring layout. Be sure to test IC on circuit board before use.
After circuit board is replaced, test IC again.
that impedance between power supply and output terminal will
be kept low; therefore, IC output terminal may be short-
circuited internally if excessive surge voltage is applied
accidentally from outside. To prevent circuit board from
burning in such a case, take safety measures such as
installation of a fuse.
CC
CC1
and GND as close to IC terminal as
and V
CC2
before use.
MITSUBISHI <CONTROL / DRIVER IC>
2-PHASE STEPPER MOTOR DRIVER
M54646AP