ACT4436 Aeroflex Circuit Technology, ACT4436 Datasheet - Page 2

no-image

ACT4436

Manufacturer Part Number
ACT4436
Description
Act 4436 Dual Transceiver For Mil-std-1553/1760
Manufacturer
Aeroflex Circuit Technology
Datasheet
an
provides for the removal of the
transmitter output from the line. A
logic “1” signal applied to the
“INHIBIT” takes priority over the
condition of the data inputs and
disables
Transmitter
Figure 1). The Transmitter may be
safely operated for an indefinite
period with the bus (point A) short
circuited at 100% duty cycle.
Aeroflex Circuit Technology
LINE TO LINE
DATA IN
DATA IN
INHIBIT
LINE TO LINE
DATA OUT
DATA OUT
INPUT
STROBE
OUTPUT
Figure 1 — Transmitter Logic Waveforms Idealized
Figure 2 — Receiver Logic Waveforms Idealized (ACT4436D)
overriding
Note: DATA and DATA inputs must be complementary waveforms or 50% duty cycle average, with no delays between them,
the
and must be in the same state during off times (both high or low).
Logic
transmitter
“INHIBIT"
Waveform,
input
(See
Receiver:
bi-phase differential data at the
input and produces two TTL signals
at the output. The outputs are DATA
and DATA, and represent positive
and negative excursions of the input
beyond a pre-determined threshold
(See Receiver Logic Waveform,
Figure 2).
detect data bus signals, point A
The Receiver section accepts
The pre-set internal thresholds will
2
Note overlap
SCD4436D REV B 3/10/98/98 Plainview NY (516) 694-6700
Figure 5, exceeding 1.20 Volts
P-P and reject signals less than
0.6 Volts P-P when used with a
transformer (See Figure 5 for
transformer data and typical
connection).
input inhibits the DATA
DATA outputs. If unused, a 2K
pull-up
recommended.
A low level at the RX Strobe
to
+5
Volts
and
is

Related parts for ACT4436