ICD-87XP Advanced Trandsata, ICD-87XP Datasheet - Page 2

• Manufacturer Part Number: ICD-87XP
• Manufacturer: Advanced Trandsata

Copyright 1999-2001 Advanced Transdata Corporation . Printed in USA . June 2001
ICD-87XP PIC16F87X In-Circuit Debugger
source file using supported compilers
instruction to be executed after strolling through source codes
real-time from current program counter to the one highlighted by the cursor; can be used to step over or exit function calls
execution to a memory buffer
The ICD-87XP debugger comes with an Integrated Development Environment (IDE) software which runs under Windows 95/98/ME/2000/NT. The IDE
user interface is so intuitive that there is no learning curve to the system and users can be up and running within minutes. All information regarding the
processor and the application is available right on the screen. It provides separate windows to examine source codes, data memory, special file registers and
watch variables.
Load File - Loads COD, binary and hex files to the IDE for debug
Feature Comparison between
Package Contents:
Interface
Operating Environment
Emulation Vdd Voltage
External Break
Bits RB6, RB7
Target Frequency
Firmware Upgrade
Function Timing for 8K words:
!
!
!
!
!
14330 Midway Road . Suite 128 . Dallas . Texas . 75244
Read and Verify
Complete Program Cycle
Program Debug Module
Reset
Update all Registers
Update Registers - Updates all registers in the current program states
ICD-87XP Programmer/Debugger with ribbon cable ends in 40-pin emulation header, 28-pin SDIP emulation header, ICD
Demo Board, Win 95/98/ME/2000/NT IDE software, printed User’s Guide.
Toggle Breakpoint - Quickly enables or disables current program counter as breakpoint
MPLAB -ICD
MPLAB -ICD
Serial Port
MPLAB IDE - Win 95/98/NT
3 to 5.5 volt
None
Occupied at all times
Cannot read back target frequency
Reprogram a new firmware chip
Depends on target frequency and voltage
!
!
!
!
!
24 seconds
2 min 45 seconds
5.5 seconds
2.6 seconds
1.35 to 60 seconds
TM
Conditional Animation Break between 2 operands
and select from a list of break conditions.
TM
Add Watch Variables - Isolates special variables to be inspected in a separate window
TM
processors after a specified number of edge changes.
and ICD-87XP
Special Function Tool Buttons
There are 2 external break input sources from the
target circuit: BRK1 is an edge trigger break and
Tel [phone] Fax [phone]
Opens Device Configuration Window - Selects device type and fuse bit settings
BRK2 is an edge count break which halts the
ICD-87XP
Parallel Port
PICICD - Win 95/98/ME/2000/NT
2.5 to 6 volt
Edge trigger break input and edge count break input
Free when not in debug mode via jumper setting
Can read back target frequency in debug mode
Re-download codes to flash-based firmware chip
Independent of target frequency and voltage
!
!
!
!
!
2.5 seconds
Less than 1 min 45 seconds
4 seconds
1.2 seconds
Less than 1 second
Email: [e-mail] Web Site: http://www.adv-transdata.com
Animation Trace - Enables saving the non-real-time program
registers to be saved to the non-real-time animation
The Animation Trace allows users to specify 3
trace in addition to the W, STATUS and FSR
Show Next Statement - Quickly returns to the next
registers, opcode and source instructions.
AdvancedTransdAtA
Run to Cursor - Executes codes in
Compile - Compiles the