MAX881 Maxim, MAX881 Datasheet - Page 6

• Manufacturer Part Number: MAX881
• Description: Low-Noise Bias Supply in MAX with Power-OK for GaAsFET PA
• Manufacturer: Maxim

The MAX881R, a low-noise, inverting, regulated charge-
pump power supply, is designed for biasing GaAsFET
devices such as power-amplifier modules in cellular
handsets.
The applied input voltage (V
voltage at NEGOUT by a capacitive charge pump. This
voltage is regulated by an internal linear regulator at
OUT (Figure 1). With FB connected to GND, V
regulated at -2V. Alternatively, use a voltage-divider at
FB to adjust the output voltage between -0.5V and -(V
- 0.6V) (see the section Setting the Output Voltage ).
The internal linear regulator reduces the ripple noise
induced by the charge-pump inverter to 1mVp-p at
OUT (circuit of Figure 3b). In addition, the excellent AC
rejection of the linear regulator attenuates noise from
the incoming supply.
The MAX881R has an active-low, open-drain, power-OK
(POK) output. This output goes low when OUT reaches
92.5% of the regulated output voltage. POK can be
used to drive the gate of a P-MOSFET that switches
power to the GaAsFET power amplifier (Figure 2), there-
by ensuring that the power amplifier is not powered
before the required negative bias voltage is present.
Use a 50kΩ or larger pull-up resistor to signal a logic
high when POK goes high impedance.
The MAX881R features a shutdown mode that reduces
supply current to less than 1µA over temperature. SHDN
is an active-low, logic-level input. Start-up time coming
out of shutdown mode is typically 0.5ms. OUT and
NEGOUT are switched to GND in shutdown mode.
Low-Noise Bias Supply in µMAX
with Power-OK for GaAsFET PA
6
________________Detailed Description
Figure 2. Using the
_______________________________________________________________________________________
MAX881R
OUT
POK
POK Function
C4
TO PA
GATE BIAS
IN
) is inverted to a negative
100k
Power-OK Signal
Shutdown Mode
POWER AMPLIFIER
V
CC
FOR
P
TO
POWER
AMPLIFIER
OUT
IN
is
Select either a fixed or adjustable output for the
MAX881R. Connect FB to GND for a fixed -2V output
(Figure 3). Select an alternative output voltage by con-
necting FB to the midpoint of a resistor-divider from
OUT to GND (Figure 4). When operating under full load
(4mA), the voltage at IN should be at least 0.6V higher
than the absolute voltage required at OUT. Note that
the minimum input voltage required for operation is
2.5V, regardless of the desired output voltage.
Choose R1 to be between 100kΩ and 400kΩ and cal-
culate R2. For greater accuracy, use resistors with 1%
or better tolerance.
Figure 3a. Standard Application Circuit for Minimum Capacitor
Values
Figure 3b. Standard Application Circuit for Minimum Output
Noise
ON
ON
0.22 F
0.22 F
1 F
OFF
1 F
OFF
C1
C1
C2
C2
Applications Information
R2 = R1 (2 x
C1+
C1-
SHDN
NEGOUT
C1+
C1-
SHDN
NEGOUT
Setting the Output Voltage
MAX881R
MAX881R
GND
GND
V
V
IN
IN
IN
IN
|
V
FB
FB
OUT
OUT
POK
OUT
POK
|
- 1)
C4
10 F
C3
1 F
C4
4.7 F
C3
0.22 F
V
V
OUT
OUT
= -2V
= -2V