LPC2104 Philips Semiconductors (Acquired by NXP), LPC2104 Datasheet - Page 23

• Manufacturer Part Number: LPC2104
• Description: LPC2104/2105/2106; Single-chip 32-bit Microcontrollers; 128 KB Isp/iap Flash With 64 KB/32 KB/16 KB RAM;; Package: SOT313-2 (LQFP48)
• Manufacturer: Philips Semiconductors (Acquired by NXP)

Philips Semiconductors
7. Limiting values
9397 750 11499
Product data
Table 8:
In accordance with the Absolute Maximum Rating System (IEC 60134).
[1]
[2]
[3]
[4]
[5]
[6]
Symbol Parameter
V
V
V
V
I
I
T
P
stg
DD1.8
DD3
i
i
The following applies to the Limiting values:
a) Stresses above those listed under Limiting values may cause permanent damage to the device.
b) This product includes circuitry specifically designed for the protection of its internal devices from
c) Parameters are valid over operating temperature range unless otherwise specified. All voltages
Not to exceed 4.6 V.
Including voltage on outputs in 3-state mode.
Only valid when the V
The peak current is limited to 25 times the corresponding maximum current.
Dependent on package type.
This is a stress rating only and functional operation of the device at these or any conditions other
than those described in
of this specification is not implied.
the damaging effects of excessive static charge. Nonetheless, it is suggested that conventional
precautions be taken to avoid applying greater than the rated maximum.
are with respect to V
Supply voltage, internal rail
Supply voltage, external rail
DC input voltage, 5 V tolerant I/O
pins
DC input voltage, other I/O pins
DC supply current per supply pin
DC ground current per ground pin
Storage temperature
Power dissipation (based on
package heat transfer, not device
power consumption)
Limiting values
[3][4]
Rev. 02 — 11 June 2003
DD3
SS
supply voltage is present.
unless otherwise noted.
Section 8 “Static characteristics”
[6]
[2][3]
[5]
[5]
LPC2104/2105/2106
Conditions
Single-chip 32-bit microcontrollers
and
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
Section 9 “Dynamic characteristics”
Min
-
-
1.5
0.5
0.5
0.5
0.5
40
Max
+2.5
+3.6
6.0
V
0.5
100
100
125
-
DD3
+
Unit
V
V
V
V
mA
mA
W
C
23 of 34