AT94S05AL ATMEL Corporation, AT94S05AL Datasheet - Page 4

• Manufacturer Part Number: AT94S05AL
• Description: The Secure Fpslic Combines Our AT94K05AL Fpslic Device And a Secure Configuration EePROM in a Single 256-pin Cabga Package.
• Manufacturer: ATMEL Corporation

Internal Architecture
FPSLIC and
Configurator
Interface
Programming and
Configuration Timing
Characteristics
The FPSLIC Configurator
Serial Bus Overview
4
AT94S Secure Family
For details of the AT94S Secure FPSLIC architecture, please refer to the AT94K
FPSLIC datasheet and the AT17 Series Configuration Memory datasheet, available on
the Atmel web site at http://www.atmel.com. This document only describes the differ-
ences between the AT94S Secure FPSLIC and the AT94K FPSLIC.
•
•
•
External Data pins allow for In-System Programming of the device and setting of the
EEPROM-based security bit. When the security bit is set (active) this programming con-
nection will only respond to a device erase command. Data cannot be read out of the
external programming/data pins when the security bit is set. The part can be re-pro-
grammed, but only after first being erased.
Atmel’s Configurator Programming Software (CPS), available from the Atmel web site
(http://www.atmel.com/atmel/products/prod185.htm), creates the programming algo-
rithm for the embedded configurator; however, if you are planning to write your own
software or use other means to program the embedded configurator, the section below
includes the algorithm and other details.
The FPSLIC Configurator is a serial EEPROM memory which is used to load program-
mable devices. This document describes the features needed to program the
Configurator from within its programming mode (i.e., when SER_EN is driven Low).
Reference schematics are supplied for ISP applications.
The serial bus is a two-wire bus; one wire (cSCK) functions as a clock and is provided
by the programmer, the second wire (cSDA) is a bi-directional signal and is used to pro-
vide data and control information.
Information is transmitted on the serial bus in messages. Each MESSAGE is preceded
by a Start Condition and ends with a Stop Condition. The message consists of an inte-
ger number of bytes, each byte consisting of 8 bits of data, followed by a ninth
Acknowledge Bit. This Acknowledge Bit is provided by the recipient of the transmitted
byte. This is possible because devices may only drive the cSDA line Low. The system
must provide a small pull-up current (1 kΩ equivalent) for the cSDA line.
The MESSAGE FORMAT for read and write instructions consists of the bytes shown in
“Bit Format” on page 5.
While writing, the programmer is responsible for issuing the instruction and data. While
reading, the programmer issues the instruction and acknowledges the data from the
Configurator as necessary.
Fully In-System Programmable and Re-programmable
When Security Bit Set:
–
–
–
When Security Bit Cleared:
–
–
–
Data Verification Disabled
Data Transfer to FPSLIC not Externally Visible
Secured EEPROM Will Only Boot the FPSLIC Device or Respond to a Chip
Erase
Entire Chip Erase Performed
In-System Programming Enabled
Data Verification Enabled
2314C–FPSLI–06/02