MAX1729 Maxim, MAX1729 Datasheet - Page 6

• Manufacturer Part Number: MAX1729
• Description: ECB and LCD Display Bias Supply with Accurate Output Voltage and Temperature Compensation
• Manufacturer: Maxim

ECB and LCD Display Bias Supply with Accurate
Output Voltage and Temperature Compensation
The MAX1729 is designed to provide bias voltage for
ECB or LCD displays. It is composed of a step-up
DC-DC converter followed by a linear regulator
(Figure 1), a combination that provides step-up/step-
down voltage conversion while minimizing output rip-
ple. The device allows you to adjust a display’s color or
contrast by dynamically adjusting the MAX1729’s out-
put voltage using a PWM control signal. In internal
feedback mode, the output voltage is adjustable
between +2.5V and +16V. In external feedback mode,
the output voltage is adjustable, and its range is set by
a resistor network that is programmed to match the out-
put voltage range of LCD/ECB displays needing a max-
imum output up to +18V.
The MAX1729’s DC-DC boost converter is implemented
with an on-chip N-channel MOSFET, a diode, and an
error comparator. The IC’s unique PFM control system
varies the on-time and off-time of the switch based on the
6
PIN
10
_______________________________________________________________________________________
1
2
3
4
5
6
7
8
9
NAME
COMP
CTLIN
GND
OUT
REF
TC
FB
PS
LX
IN
Supply Input. Bypass with 0.1µF capacitor to ground. Connect to supply side of inductor (L1).
Temperature-Sensor Output. Bypass to GND with a 1000pF capacitor.
Reference Voltage Output. Bypass to GND with a 0.1µF capacitor.
Compensation Pin. In internal feedback mode (Figure 2), bypass with a 1µF capacitor. In external feedback
mode, COMP is a buffered inverse version of CTLIN (Figure 3).
Feedback and Mode Control Input. Connect to GND for internal feedback mode operation.
Control Input. Drive low for more than 1.2ms to put the device into shutdown.
Bypass to GND with a 1.0µF capacitor.
Output of boost converter and input to LDO. Bypass to GND with a 0.068µF capacitor.
Drain of the internal MOSFET Switch
Ground
Detailed Description
Boost Converter
boost converter’s input and output voltage values, as fol-
lows:
where K is typically 8V-µs. This timing maintains discon-
tinuous conduction and sets the peak inductor current
(I
where L is the inductance of L1 (Figures 2, 3, and 4).
When the error comparator detects that the drop across
the linear regulator (V
ly 0.6V, the internal switch is turned on (t
current through the inductor ramps to I
t
ON
PEAK
FUNCTION
, the switch is turned off for at least t
) to:
t
t
ON
OFF
PS
I
PEAK
=
- V
V
OUT
K
IN
V
=
PS
) is less than approximate-
Pin Description
K
K
L
V
IN
PEAK
OFF
ON
. At the end of
, allowing the
initiates) and