SIM3C1XX-B-DK Silicon_Laboratories, SIM3C1XX-B-DK Datasheet - Page 3

• Manufacturer Part Number: SIM3C1XX-B-DK
• Description: Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant
• Manufacturer: Silicon_Laboratories

3. Hardware Setup
3.1. Using the MCU Card Alone
Refer to Figure 2 for a diagram of the hardware configuration when using the MCU card without a UDP
motherboard.
Notes:
1. Connect the USB Debug Adapter to the 10-pin debug connector (J31) on the MCU card with the 10-pin
2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
3. Connect the other end of the USB cable to a USB Port on the PC.
4. Move the SW5 System Power Select switch to the upper WALL position.
5. Verify that the 5V WALL (J14), VDD (J15), and VIO (J17) Imeasure jumpers are all populated.
6. Verify that the VIOHD Selection jumper (J18) is in the upper position between VIO and VIOHD.
7. Connect the ac/dc power adapter to the wall outlet and to the power jack on the board labeled Power (P1).


ribbon cable.
Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
Remove power from the MCU card and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the MCU card. Connecting or disconnecting the cable when the devices have power can
damage the device and/or the USB Debug Adapter.
Power
Figure 2. Hardware Setup using the MCU Card Alone
Rev. 0.1
USB Debug Adapter
Header
Power Select
Switch
Imeasure
Jumpers
UDP SiM3C1xx
Connectivity
Jumper
VIOHD
VCP
3