CMX602B Consumer Microcircuits Limited, CMX602B Datasheet - Page 10

• Manufacturer Part Number: CMX602B
• Description: Calling Line Identifier Plus Call Waiting Type ii
• Manufacturer: Consumer Microcircuits Limited

Calling Line Identifier
Note that, if enabled, the Data Retiming block will interpret the FSK Channel Seizure signal (a sequence of
alternating mark and space bits) as valid received characters, with values of 55 (hex). Similarly it may
interpret speech or other signals as random characters.
If the Data Retiming facility is not required, the RXCK input to the CMX602B should be kept high. The
asynchronous data from the FSK Demodulator will then be connected directly to the RXD output pin, and
the IRQN output will not be activated by the FSK signal. This case is illustrated in Figure 5b.
1.5.7
This block is enabled when the CMX602B is set to Tone Alert Detect mode. It will then monitor the
received signal for the presence of simultaneous 2130 and 2750Hz tones of sufficient level and duration.
Two digital bandpass filters, centred around 2130Hz and 2750Hz, are used within the block to give
additional rejection of interfering signals.
The CMX602B DET output will be set high while a Tone Alert signal is detected.
When the DET output goes low at the end of the Tone Alert signal, then if the DET output had been high
for a time within the CAS qualifying time TqCAS limits (see 1.7.1) , then the IRQN output will be pulled low
and will remain low until the CMX602B is switched out of Tone Alert Detect mode. Note that the TqCAS
timing has been optimised for the detection of 75 to 85ms Tone Alert (CAS) signals used in off-hook
 2003 CML Microsystems Plc
td = Internal CMX602B delay; max. 1 S
Tone Alert Detector
Figure 5b : FSK Operation Without Data Retiming (RXCK always high)
Figure 5a : FSK Operation With Data Retiming
tclo = RXCK low time; min 1 S
10
tchi = RXCK high time; min 1 S
CMX602B
D/602B/2