FX614 Consumer Microcircuits Limited, FX614 Datasheet - Page 11

• Manufacturer Part Number: FX614
• Description: Bell 202 Compatible Modem Fx614
• Manufacturer: Consumer Microcircuits Limited

Bell 202 Compatible Modem
So to use the retiming option the CLK input should be held low until the RDYN output is pulled low. When the
RDYN pin goes low the next data bit should be applied at the TXD input and the CLK input pulled high and
then low within the time limits set out in Figure 6c.
To ensure synchronisation between the controlling device and the FX614 when entering Tx retiming mode the
TXD pin must be held at a constant logic level from when the CLK pin is first pulled low to the end of loading in
the second retimed bit. Similarly when exiting Tx retiming mode the TXD pin should be held at the same logic
level as the last retimed bit for at least 2 bit times after the CLK line is pulled high.
If the data retiming facility is not required, the CLK input to the FX614 should be kept high at all times. The
asynchronous data to the FSK modulator will then be connected directly to the TXD input pin. This is
illustrated in Figure 6d and will also be the case when transmitting 5bits/sec or 150bits/sec data which have no
retime option.
1997 Consumer Microcircuits Limited
Td = Internal FX614 delay; max 1 s
Tr = RDYN low to CLK going low; max 800 s
Tchi = CLK high time; min 1 s
Figure 6d FSK Operation without Tx Data Retiming (CLK always high)
Figure 6c FSK Operation with Tx Data Retiming
11
Ts = data set up time; min 1 s
Th = data hold time; min 1 s
D/614/4
FX614