LMX2470 National Semiconductor Corporation, LMX2470 Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
LMX2470
Manufacturer Part Number
LMX2470
Description
2.6 Ghz Delta-sigma Fractional-n Pll With 800 Mhz Integer-n Pll
Manufacturer
National Semiconductor Corporation
Datasheet
1.LMX2470.pdf
(36 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Bench Test Setups
Input Impedance Measurement Procedure
The above block diagram shows the test procedure measur-
ing the input impedance for the LMX2470. This applies to the
FinRF, FinIF, and OSCin pins. The basic test procedure is to
calibrate the network analyzer, ensure that the part is pow-
ered up, and then measure the input impedance. The net-
work analyzer can be calibrated by using either calibration
standards or by soldering resistors directly to the evaluation
board. An open can be implemented by putting no resistor, a
short can be implemented by using a 0 ohm resistor, and a
short can be implemented by using two 100 ohm resistors in
parallel. Note that no DC blocking capacitor is used for this
test procedure. This is done with the PLL removed from the
PCB. This requires the use of a clamp down fixture that may
not always be generally available. If no clamp down fixture is
available, then this procedure can be done by calibrating up
to the point where the DC blocking capacitor usually is, and
then adding a 0 ohm resistor back for the actual measure-
(Continued)
17
ment. Once that the network analyzer is calibrated, it is
necessary to ensure that the PLL is powered up. This can be
done by toggling the power down bits (RF_PD and IF_PD)
and observing that the current consumption indeed in-
creases when the bit is disabled. Sometimes it may be
necessary to apply a signal to the OSCin pin in order to
program the part. If this is necessary, disconnect the signal
once it is established that the part is powered up. It is useful
to know the input impedance of the PLL for the purposes of
debugging RF problems and designing matching networks.
Another use of knowing this parameter is make the trace
width on the PCB such that the input impedance of this trace
matches the real part of the input impedance of the PLL
frequency of operation. In general, it is good practice to keep
trace lengths short and make designs that are relatively
resistant to variations in the input impedance of the PLL.
20059371
www.national.com