ST7565S ETC-unknow, ST7565S Datasheet - Page 49

• Manufacturer Part Number: ST7565S
• Description: 65 X 132 Dot Matrix Lcd Controller/driver
• Manufacturer: ETC-unknow

ST7565S
Static Indicator Register Set
This command sets two bits of data into the static indicator register, and is used to set the static indicator into a blinking mode.
* Disabled bit (set “0”)
Static Indicator Register Set Sequence
Power Save (Compound Command)
When the display all points ON is performed while the display is in the OFF mode, the power saver mode is entered, thus
greatly reducing power consumption.
The power saver mode has two different modes: the sleep mode and the standby mode. When the static indicator is OFF, it is
the sleep mode that is entered. When the static indicator is ON, it is the standby mode that is entered.
In the sleep mode and in the standby mode, the display data is saved as is the operating mode that was in effect before the
power saver mode was initiated, and the MPU is still able to access the display data RAM.
Refer to figure 28 for power save off sequence.
Ver 0.3b
A0
0
/RD /WR
E
1
R/W
0
D7 D6 D5 D4 D3 D2 D1 D0
*
Display all point OFF
Static indicator ON (2 bytes)
Sleep mode cancel
*
Static indicator OFF
Power save OFF
Display all point ON
*
Sleep mode
Display OFF
*
NO
*
*
Static indicator mode set
Static indicator register set
1
0
1
0
1
0
1
0
Figure 27
Figure 28
Set complete ?
OFF
ON (blinking at approximately one second intervals)
ON (blinking at approximately 0.5 second intervals)
ON (constantly on)
49/72
YES
Static indicator mode clear
Indicator Display State
( Display all point OFF )
Standby mode cancel
Static indicator ON
Power save OFF
Display all point ON
Standby mode
Display OFF
2002/06/23