EMC2301 Standard Microsystems Corp., EMC2301 Datasheet - Page 27

• Manufacturer Part Number: EMC2301
• Description: Rpm-based Pwm Fan Controller
• Manufacturer: Standard Microsystems Corp.

ADDR
2Ah
2Bh
ADDR
29h
RPM-Based PWM Fan Controller
Datasheet
SMSC EMC2301
R/W
R/W
R/W
5.4
R/W
R/W
5.5
5.5.1
5.5.2
REGISTER
PWM Polarity
PWM Output
REGISTER
Interrupt
Enable
Config
Config
Fan
The Fan Interrupt Enable controls the masking for the Fan channel. When a channel is enabled, it will
cause the ALERT# pin to be asserted when an error condition is detected.
Bit 0 - FAN_INT_EN - Allows the Fan to assert the ALERT# pin if an error condition is detected.
The PWM Config registers control the output type and polarity of all PWM outputs.
PWM Polarity Config - 2Ah
Bit 0 - POLARITY - Determines the polarity of the PWM.
PWM Output Config - 2Bh
Bit 0 - PWM_OT - Determines the output type of the PWM driver.
Fan Interrupt Enable Register
PWM Configuration Registers
‘0’ (default) - An error condition on Fanwill not cause the ALERT# pin to be asserted, however the
status registers will be updated normally.
‘1’ - An error condition (Stall, Spin Up, Drive Fail) on the Fan will cause the ALERT# pin to be
asserted.
‘0’ (default) - the Polarity of the PWM driver is normal. A drive setting of 00h will cause the output
to be set at 0% duty cycle and a drive setting of FFh will cause the output to be set at 100% duty
cycle.
‘1’ - The Polarity of the PWM driver is inverted. A drive setting of 00h will cause the output to be
set at 100% duty cycle and a drive setting of FFh will cause the output to be set at 0% duty cycle.
‘0’ (default) - The PWM output is configured as an open drain output.
‘1’ - The PWM output is configured as a push-pull output.
B7
B7
-
-
-
B6
Table 5.5 PWM Configuration Registers
Table 5.4 Fan Interrupt Enable Register
-
-
B6
-
B5
-
-
B5
DATASHEET
-
27
B4
-
-
B4
-
B3
B3
-
-
-
B2
B2
-
-
-
Revision 1.2 (03-22-10)
B1
B1
-
-
-
INT_EN
POLARITY
FAN_
PWM_OT
B0
B0
DEFAULT
DEFAULT
00h
00h
00h