CEM-1203 CUI INC, CEM-1203 Datasheet - Page 3

• Manufacturer Part Number: CEM-1203
• Description: Magnetic Buzzer
• Manufacturer: CUI INC

Mechanical Characteristics
Item
Solderability
Soldering Heat Resistance
Terminal Mechanical Strength
Vibration
Drop Test
Environment Test
Item
High temp. test
Low temp. test
Thermal shock
Temp./Humidity cycle
Phone: [phone]
Fax: [phone]
Test Condition
Lead terminals are immersed in rosin for 5
seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Lead terminals are immersed up to 1.5mm from
the buzzer’s body in solder bath of 260 ±5°C
for 3 ±1 seconds.
Apply force of 9.8 N (1.0 kg) to each terminal in
each axial direction for 10 seconds.
The buzzer will be measured after applying
a vibration amplitude of 1.5 mm with 10 to 55
Hz band of vibration frequency to each of the 3
perpendicular directions for 2 hours.
The part is to be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axis (X, Y, Z) for a total of 9 drops.
Test Condition
The part will be subjected to +70°C for
96 hours.
The part will be subjected to -30°C for
96 hours
The part will be subjected to 10 cycles. One
cycle will consist of:
The part shall be subjected to 10 cycles. One
cycle will consist of:
Part No: CEM-1203(42)
Description: magnetic buzzer
www.cui.com
20050 SW 112th Ave.
Evaluation Standard
Evaluation Standard
90% min. of lead terminals
should be wet with solder.
(Except the edge of the terminal)
No in interference in operation.
No damage or cutting off.
After the test, the part shall meet
specifications without any
damage to the appearance. After
4 hours at +25°C, the SPL
should be within ±10 dBA of the
initial SPL.
After the test, the part shall meet
specifications without any
damage to the appearance. After
4 hours at +25°C, the SPL
should be within ±10 dBA of the
initial SPL.
Tualatin, OR 97062
Date: 8/11/2006
Unit: mm
Page No: 3 of 5