ATA5744 ATMEL Corporation, ATA5744 Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/0/79/atmel_corporation_sml.jpg)
ATA5744
Manufacturer Part Number
ATA5744
Description
Ata5744 Uhf Ask Receiver
Manufacturer
ATMEL Corporation
Datasheet
1.ATA5744.pdf
(20 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ATA5744N-TKQY
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Company:
Part Number:
ATA5744NTKQY19
Manufacturer:
ATMEL
Quantity:
3 527
Company:
Part Number:
ATA5744NTKSY
Manufacturer:
ATMEL
Quantity:
6 601
Company:
Part Number:
ATA5744NTKSY19
Manufacturer:
ATMEL
Quantity:
4 451
4.3
4.4
4893A–RKE–11/05
Pin RSSI
ASK Demodulator and Data Filter
The output voltage of the RSSI amplifier (VRSSI) is available at pin RSSI. Using the RSSI output
signal, the signal strength of different transmitters can be distinguished. The usable input power
range P
Since different RF input networks may exhibit slightly different values for the LNA gain, the sen-
sitivity values given in the electrical characteristics refer to a specific input matching. This
matching is illustrated in
Figure 4-1.
The signal coming from the RSSI amplifier is converted into the raw data signal by the ASK
demodulator.
An automatic threshold control circuit (ATC) is employed to set the detection reference voltage
to a value where a good signal-to-noise ratio is achieved. This circuit also implies the effective
suppression of any kind of inband noise signals or competing transmitters. If the S/N ratio
exceeds 10 dB, the data signal can be detected properly.
The output signal of the demodulator is filtered by the data filter before it is fed into the digital
signal processing circuit. The data filter improves the S/N ratio as its passband can be adopted
to the characteristics of the data signal. The data filter consists of a 1st-order highpass and a
1st-order lowpass filter.
The highpass filter cut-off frequency is defined by an external capacitor connected to pin CDEM.
The cut-off frequency of the highpass filter is defined by the following formula:
Recommended values for CDEM are given in the electrical characteristics.
The cut-off frequency of the lowpass filter is defined by the selected baudrate range
(BR_Range). BR_Range is defined by the pins BR_0 and BR_1. BR_Range must be set in
accordance to the used baudrate.
fcu_DF
Ref
=
is –100 dBm to –55 dBm.
---------------------------------------------------- -
2
RSSI Characteristics
R
1
1
3.0
2.8
2.6
2.4
2.2
2.0
1.8
1.6
1.4
1.2
1.0
CDEM
Figure 3-3
-130.0
-110.0
105°C
and exhibits the best possible sensitivity.
25°C
T
-90.0
amb
= 40°C
P
Ref
min.
(dBm)
-70.0
max.
-50.0
-30.0
ATA5744
7