TS200-EX MORNSUN Science& Technology Ltd., TS200-EX Datasheet - Page 2

• Manufacturer Part Number: TS200-EX
• Description: Tsx00-ex Isolating Switching Barrier
• Manufacturer: MORNSUN Science& Technology Ltd.

Ambient
temperature
Package
Protection Grade
Weight
INSTALLATION
STANDARDS AND CERTIFICATIONS
Explosion protection certification mark
Explosion protection certification
parameters
Certified by: CHINA NATIONAL QUALITY SUPERVISION AND TEST CENTRE FOR
EXPLOSION PROTECTED ELECTRICAL PRODUCTS
No.:CNEx08.0003
OTHER CHARACTERISTICS
APPLICATION CIRCUIT DIAGRAM
DIN35mm standard rail installation:
1. Upside of the instrument card in the rail;
2. Push underside of the instrument into the rail.
The copyright and authority for the interpretation of the products are reserved by Mornsun
Operation temperature:-20°C ~ +60°C
Transport and Storage temperature:-40°C ~ +85°C
35mm DIN-rail package, hot plug, thickness: 22.5mm, Plastic
UL94-V0
IP20(IEC60529 / EN60529)
About 66g
[Exia]IIC
Um=250Vrms, Uo=10.5V, Io=14mA
Po=37mW, Co=1.6uF, Lo=150mH
1． The explosion protection grade of the barrier
2． Take inconsideration of hazardous end output
3． The safety parameters of Barrier’s intrinsic
4． Select suitable Safety barrier which matches
5． Apply necessary protections, avoid influence
isolating barrier belongs to affiliated device. It is
installed at safe area, as a connection between
intrinsic safety devices in the hazardous area and
non-intrinsic safety devices in the safe area. By
limiting the energy to a certain safe amount, it
ensures the safety of in spot devices and people.
Selection
explosion protection system:
Operation notes:
1. Please read the user manual carefully before
2. Please do not use this product in hazardous
3. The power supply of this product should be
4. To avoid invalid explosion protection function, or
1. Use a screwdriver (Width of edge ≤ 6mm), cut in
2. Boost up the screwdriver and prize the metal
APPLICATION
EXPLOSION PROTECTION SYSTEM
DISASSEMBLY
Pull the instrument out of the rail.
In intrinsic safety explosion protection systems,
the metal card lock from the underside;
card lock downwards;
must be equal to or higher than that of in spot
intrinsic safety explosion protection device.
resistance and loop resistance, ake sure the
barrier’s output voltage meets the minimum
operation voltage requirement of in spot intrinsic
safety device.
safety end meets:
Uo ≤ UI, Io ≤ Iin, Po ≤ Pin
Co ≥ Cin, Lo ≥ Lin
the in spot intrinsic safety device for the power’s
phase, signal type and transmission mode.
the in spot intrinsic safety device’s operation
from leakage current that generated by safety
barrier.
Specifications subject to change without notice.
using. If any questions please contact our
technical support department.
area.
24VDC power source. It is forbidden to use
220VAC power supply.
any failure, users disassemble this product is
forbidden.
TSX00-EX
regulations
IN
A/1-2009
INTRINSICALLY
for
Page 2 of 3
intrinsic
SAFE
safety