M25P128 Numonyx, B.V., M25P128 Datasheet - Page 13
![no-image](/images/no-image-200.jpg)
M25P128
Manufacturer Part Number
M25P128
Description
128 Mbit (Multilevel), low-voltage, Serial Flash memory with 50-MHz SPI bus interface
Manufacturer
Numonyx, B.V.
Datasheet
1.M25P128.pdf
(45 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M25P128
Manufacturer:
ST
Quantity:
20 000
Part Number:
M25P128-VME6
Manufacturer:
MICRON/镁光
Quantity:
20 000
Part Number:
M25P128-VME6G
Manufacturer:
MICRON/镁光
Quantity:
20 000
Company:
Part Number:
M25P128-VME6GB
Manufacturer:
NUMONYX
Quantity:
1 920
Company:
Part Number:
M25P128-VME6GB
Manufacturer:
SILICON
Quantity:
2 310
Part Number:
M25P128-VME6GB
Manufacturer:
ST
Quantity:
20 000
Part Number:
M25P128-VME6TG
Manufacturer:
MICRON/美光
Quantity:
20 000
Company:
Part Number:
M25P128-VME6TGB
Manufacturer:
BOURNS
Quantity:
550 000
Company:
Part Number:
M25P128-VME6TGB
Manufacturer:
NUMONYX
Quantity:
8 000
M25P128
4.5
4.6
4.7
Active power and standby power modes
When Chip Select (S) is Low, the device is selected, and in the Active Power mode.
When Chip Select (S) is High, the device is deselected, but could remain in the Active Power
mode until all internal cycles have completed (Program, Erase, Write Status Register). The
device then goes in to the Standby Power mode. The device consumption drops to I
Status Register
The Status Register contains a number of status and control bits that can be read or set (as
appropriate) by specific instructions. See
detailed description of the Status Register bits.
Protection modes
The environments where non-volatile memory devices are used can be very noisy. No SPI
device can operate correctly in the presence of excessive noise. To help combat this, the
M25P128 features the following data protection mechanisms:
●
●
●
●
●
Power On Reset and an internal timer (t
changes while the power supply is outside the operating specification.
Program, Erase and Write Status Register instructions are checked that they consist of
a number of clock pulses that is a multiple of eight, before they are accepted for
execution.
All instructions that modify data must be preceded by a Write Enable (WREN)
instruction to set the Write Enable Latch (WEL) bit. This bit is returned to its reset state
by the following events:
–
–
–
–
–
–
The Block Protect (BP2, BP1, BP0) bits allow part of the memory to be configured as
read-only. This is the Software Protected Mode (SPM).
The Write Protect (W/V
Status Register Write Disable (SRWD) bit to be protected. This is the Hardware
Protected Mode (HPM).
Power-up
Write Disable (WRDI) instruction completion
Write Status Register (WRSR) instruction completion
Page Program (PP) instruction completion
Sector Erase (SE) instruction completion
Bulk Erase (BE) instruction completion
PP
) signal allows the Block Protect (BP2, BP1, BP0) bits and
Section 6.4: Read Status Register (RDSR)
PUW
) can provide protection against inadvertent
Operating features
CC1
for a
13/45
.