IR3629AMPBF International Rectifier, IR3629AMPBF Datasheet - Page 21

• Manufacturer Part Number: IR3629AMPBF
• Description: High Frequency Synchronous PWM Buck Controller in a 12-Lead MLPD Package.
• Manufacturer: International Rectifier

Specifications of IR3629AMPBF

• Package: 12-Lead MLPD
• Circuit: Sync PWM Controller
• Vcc (min): 4.0
• Vcc (max): 30
• Switch Freq (khz): Internal 300kHz
• Pbf: PbF Option Available

11/29/2007
Stencil Design
Reducing the amount of solder deposited will minimize the occurrence of lead shorts. Since for 0.5mm
pitch devices the leads are only 0.25mm wide, the stencil apertures should not be made narrower;
openings in stencils < 0.25mm wide are difficult to maintain repeatable solder release.
lead land.
much solder is deposited on the center pad the part will float and the lead lands will be open.
opening minus an annular 0.2mm pull back to decrease the incidence of shorting the center land to the
lead lands when the part is pushed into the solder paste.
The stencil apertures for the lead lands should be approximately 80% of the area of the lead lands.
The stencil lead land apertures should therefore be shortened in length by 80% and centered on the
The land pad aperture should deposit approximately 50% area of solder on the center pad. If too
The maximum length and width of the land pad stencil aperture should be equal to the solder resist
IR3629/IR3629A MPbF
21