MAX4854HL Maxim, MAX4854HL Datasheet - Page 8

• Manufacturer Part Number: MAX4854HL
• Description: The MAX4854H/MAX4854HL analog switches operate from a single +2V to +5
• Manufacturer: Maxim

(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information
go to www.maxim-ic.com/packages.)
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
8
© 2005 Maxim Integrated Products
Quad SPST, High-Bandwidth, Signal Line
Protection Switch
_____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
NOTES:
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.20 mm AND 0.25 mm
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220 REVISION C.
JESD 95-1 SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED
WITHIN THE ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR
MARKED FEATURE.
FROM TERMINAL TIP.
L C
0.10 C
Printed USA
D
L C
A
A2
A1
0.08 C
D/2
E/2
E
L
(NE - 1) X e
EXPOSED PAD VARIATIONS
L C
e
is a registered trademark of Maxim Integrated Products.
D2/2
e
PACKAGE OUTLINE
12, 16L, THIN QFN, 3x3x0.8mm
PACKAGE OUTLINE
12, 16L, THIN QFN, 3x3x0.8mm
D2
b
(ND - 1) X e
e
21-0136
k
21-0136
C L
0.10 M C A B
Package Information
E2/2
L
DOWN
BONDS
ALLOWED
E2
L
E
E
2
1
2
2