MAX4383 Maxim, MAX4383 Datasheet
MAX4383
Available stocks
Related parts for MAX4383
MAX4383 Summary of contents
Page 1
... Ultra-Small 6-Pin SC70, 6-Pin SOT23, 10-Pin µMAX, 14-Pin TSSOP, and 20-Pin TSSOP Packages Applications PART MAX4380EXT-T MAX4380EUT-T MAX4381EUB MAX4382EUD MAX4382ESD MAX4382EEE MAX4383EUD MAX4383ESD MAX4383ESE MAX4383EEE MAX4384EUP OUT TOP VIEW 75 Pin Configurations continued at end of data sheet. Features Ordering Information PIN- TOP ...
Page 2
... TSSOP (derate 9.1mW/°C above +70°C).........727mW Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or at any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. DC ELECTRICAL CHARACTERISTICS– ...
Page 3
Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable DC ELECTRICAL CHARACTERISTICS–Single Supply (V = +5V / unless otherwise noted. Typical ...
Page 4
Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable DC ELECTRICAL CHARACTERISTICS–Dual Supply (continued +5V -5V OUT unless otherwise noted. Typical ...
Page 5
Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable AC ELECTRICAL CHARACTERISTICS–Single Supply (continued +5V +1.5V / +1V/ +25°C, unless ...
Page 6
Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable (V = +5V +1.5V VCL LARGE-SIGNAL GAIN FLATNESS vs. FREQUENCY 0 OUT P-P 0.2 0.1 0 -0.1 ...
Page 7
Ultra-Small, Low-Cost, 200MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable (V = +5V +1.5V VCL POWER-SUPPLY REJECTION vs. FREQUENCY 0 -10 -20 -30 -40 -50 -60 -70 -80 100k 1M ...
Page 8
Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable (V = +5V +1.5V VCL VOLTAGE NOISE vs. FREQUENCY 100 R = 100 100 ...
Page 9
... SUPPLY CURRENT vs. TEMPERATURE SUPPLY +5V SUPPLY -50 - TEMPERATURE ( C) PIN MAX4383 SO/TSSOP SO/TSSOP SO/QSOP — — — — — — — — — — — — — ...
Page 10
... Local feedback around the output stage ensures low open-loop output impedance to reduce gain sensitivity to load variations. The input stage per- mits common-mode voltages beyond the negative sup- ply and to within 2.25V of the positive supply rail ______________________________________________________________________________________ ______________________________________________________________________________________ PIN MAX4383 SO/TSSOP SO/TSSOP SO/QSOP — ...
Page 11
... V 0.1µF capacitor as close to the pin as possible. If operat- ing with dual supplies, bypass each supply with a 0.1µF capacitor. Maxim recommends using microstrip and stripline techniques to obtain full bandwidth. To ensure that the V OUT PC board does not degrade the amplifier’s perfor- mance, design it for a frequency greater than 1GHz ...
Page 12
... Capacitance and No Isolation Resistor 400 450 500 Figure 5. Small-Signal Gain vs. Frequency with Load Capacitance and 27 Isolation Resistor MAX4380 TRANSISTOR COUNT: 66 MAX4381 TRANSISTOR COUNT: 132 MAX4382 TRANSISTOR COUNT: 196 MAX4383 TRANSISTOR COUNT: 264 MAX4384 TRANSISTOR COUNT: 264 C = 15pF 10pF 5pF ...
Page 13
... INA INB+ INA INB- OUTA 7 10 OUTB N.C. 9 N.C. 8 QSOP OUTA 1 14 OUTD INA IND- INA IND+ MAX4383 INB INC+ INB INC- OUTB 7 8 OUTC SO/TSSOP DISABLEA 1 20 DISABLED OUTA 2 19 OUTD INA- ...
Page 14
... Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 14 ______________________________________________________________________________________ Package Information PACKAGE OUTLINE, SOT-23 21-0058 ...
Page 15
... Ultra-Small, Low-Cost, 210MHz, Single-Supply Op Amps with Rail-to-Rail Outputs and Disable (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information go to www.maxim-ic.com/packages.) 10 0.6±0 TOP VIEW D e FRONT VIEW ...
Page 16
... For the latest package outline information go to www.maxim-ic.com/packages.) Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...