78M6631 Maxim, 78M6631 Datasheet - Page 26

• Manufacturer Part Number: 78M6631
• Description: The Teridian™ 78M6631 is a highly integrated 3-phase power measurement and monitoring system-on-chip (SoC), with a 10MHz 8051-compatible MPU core and Single Converter Technology® containing a 22-bit deltasigma converter and 32-bit compute e
• Manufacturer: Maxim

4.1
4.2
1)
The circuit number denotes the equivalent circuit, as specified under
26
4 Pin Descriptions
Name
GNDA
GNDD
V3P3A
V3P3D
Name
IAP,
IAN,
IBP,
IBN,
ICP,
ICN
VA, VB,
VC
V1
VREF
XIN
XOUT
Pin types: P = Power, O = Output, I = Input, I/O = Input/Output
Power and Ground Pins
Analog Pins
Type
Type Circuit
O
I
I
I
I
P
P
P
P
Circuit
6
6
7
9
8
–
–
–
–
Line Current Sense Inputs: These pins are voltage inputs to the internal
A/D converter. Typically, they are connected to the outputs of current
sensors. Unused pins must be connected to V3P3A.
Line Voltage Sense Inputs: These pins are voltage inputs to the internal
A/D converter. Typically, they are connected to the outputs of resistor
dividers. Unused pins must be connected to V3P3A.
Comparator Input: This pin is a voltage input to the internal comparator.
The voltage applied to the pin is compared to the internal BIAS voltage
(1.6 V). If the input voltage is above VBIAS, the comparator output is high
(1). If the comparator output is low, a voltage fault occurs. A series 5 kΩ
resistor should be connected from V1 to the resistor divider.
Voltage Reference for the ADC. Normally disabled and left unconnected.
If enabled, a 0.1 µF capacitor to V3P3A should be connected to this pin.
Crystal Inputs: A 32 kHz crystal should be connected across these pins.
Typically, a 33 pF capacitor is also connected from XIN to GNDA and a
15 pF capacitor is connected from XOUT to GNDA. It is important to
minimize the capacitance between these pins. Refer to the crystal
manufacturer data sheet for details. If an external clock is used, a 150
mV
unconnected.
Analog ground: This pin should be connected directly to the ground
plane.
Digital ground: This pin should be connected directly to the ground plane.
Analog power supply: A 3.3 V power supply should be connected to this
pin, must be the same voltage as V3P3SYS.
System 3.3 V supply. This pin should be connected to a 3.3 V power
supply.
P-P
Table 18: Power and Ground Pins
clock signal should be applied to XIN, and XOUT should be left
Table 19: Analog Pins
Description
Description
Section 5 I/O Equivalent
Circuits.
Rev 1