AD5398A Analog Devices, AD5398A Datasheet - Page 9

• Manufacturer Part Number: AD5398A
• Description: 120 mA, Current Sinking, 10-Bit, I2C DAC
• Manufacturer: Analog Devices

Specifications of AD5398A

• Resolution (bits): 10bit
• Dac Settling Time: 250µs
• Max Pos Supply (v): +5.5V
• Single-supply: Yes
• Dac Type: Current Out
• Dac Input Format: I2C/Ser 2-wire,Ser

TERMINOLOGY
Relative Accuracy
For the DAC, relative accuracy or integral nonlinearity is a
measurement of the maximum deviation, in LSB, from a
straight line passing through the endpoints of the DAC transfer
function. A typical INL vs. code plot is shown in Figure 5.
Differential Nonlinearity (DNL)
Differential nonlinearity is the difference between the measured
change and the ideal 1 LSB change between any two adjacent
codes. A specified differential nonlinearity of ±1 LSB maximum
ensures monotonicity. This DAC is guaranteed monotonic by
design. A typical DNL vs. code plot is shown in Figure 6.
Zero-Code Error
Zero-code error is a measurement of the output error when
zero code (0x0000) is loaded to the DAC register. Ideally, the
output is 0 mA. The zero-code error is always positive in the
AD5398A because the output of the DAC cannot go below
0 mA. This is due to a combination of the offset errors in the
DAC and output amplifier. Zero-code error is expressed in mA.
Gain Error
This is a measurement of the span error of the DAC. It is the
deviation in slope of the DAC transfer characteristic from the
ideal, expressed as a percent of the full-scale range.
Rev. 0 | Page 9 of 16
Gain Error Drift
This is a measurement of the change in gain error with changes
in temperature. It is expressed in LSB/°C.
Digital-to-Analog Glitch Impulse
Digital-to-analog glitch impulse is the impulse injected into the
analog output when the input code in the DAC register changes
state. It is normally specified as the area of the glitch in nA-sec
and is measured when the digital input code is changed by
1 LSB at the major carry transition.
Digital Feedthrough
Digital feedthrough is a measurement of the impulse injected
into the analog output of the DAC from the digital inputs of
the DAC, however is measured when the DAC output is not
updated. It is specified in nA-sec and measured with a full-
scale code change on the data bus, that is, from all 0s to all 1s
and vice versa.
Offset Error
Offset error is a measurement of the difference between I
(actual) and I
function, expressed in mA. Offset error is measured on the
AD5398A with Code 16 loaded into the DAC register.
Offset Error Drift
This is a measurement of the change in offset error with a
change in temperature. It is expressed in μV/°C.
OUT
(ideal) in the linear region of the transfer
AD5398A
SINK