AD7879 Analog Devices, AD7879 Datasheet - Page 19

• Manufacturer Part Number: AD7879
• Description: Low Voltage Controller for Touch Screens
• Manufacturer: Analog Devices

Specifications of AD7879

• Resolution (bits): 12bit
• # Chan: 6
• Sample Rate: 105kSPS
• Interface: I²C/Ser 2-Wire,Ser,SPI
• Analog Input Type: SE-Uni
• Ain Range: Uni Vdd
• Adc Architecture: SAR
• Pkg Type: CSP,WLCSP

GPIO Interrupt Enable (Bit 12, Control Register 3,
Address 0x03)
The GPIO pin can operate as an interrupt source to trigger the
INT output. This is controlled by Bit 12 in Control Register 3.
If the GPIO ALERT interrupt enable bit is set to 0, the GPIO can
trigger INT . If this bit is set to 1, the GPIO cannot trigger INT .
Rev. C | Page 19 of 40
INT is asserted if the GPIO data register bit is set when the
GPIO is configured as an input, provided that INT is enabled.
INT is triggered only when the GPIO is configured as an input,
that is, when GPIO DIR = 1.
INT is cleared only when the GPIO signal or the GPIO enable
bit changes.
AD7879/AD7889