LM1203N National Semiconductor, LM1203N Datasheet - Page 12

• Manufacturer Part Number: LM1203N
• Description: IC VIDEO AMPLIFIER SYST. 28 DIP
• Manufacturer: National Semiconductor

Specifications of LM1203N

• Applications: General Purpose
• Number Of Circuits: 3
• -3db Bandwidth: 70MHz
• Current - Supply: 73mA
• Current - Output / Channel: 28mA
• Voltage - Supply, Single/dual (±): 10.8 V ~ 13.2 V
• Mounting Type: Through Hole
• Package / Case: 28-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: *LM1203N; LM1203

http
Additional Applications of the LM1203
When diode D4 at Pin 11 is switched to ground the input
video signals will be DC shifted down and clamped at a
voltage near ground (approximately 250 mV) This will dis-
able the video amplifiers and force the output DC level low
The DC outputs from other similarly configured LM1203s
could overide this lower DC level and provide the output
signals to the 75
LM1203s would share the same 390
maximum DC plus peak white output voltage should not be
allowed to exceed 7V because the ‘‘off’’ amplifier output
stage could suffer internal zener damage See Figure 3 and
text for a description of the internal configuration of the vid-
eo amplifier
www national com
FIGURE 10 Three Channel High Frequency Amplifier with Non-gated DC Feedback (Non-video Applications)
cable drivers In this case any additional
output resistor The
12
(Continued)
Figure 10 shows the configuration for a three channel high
frequency amplifier with non gated DC feedback Pin 14 is
tied low to turn on the clamp comparators (feedback amplifi-
ers) The inverting inputs (Pins 17 21 26) are connected to
the amplifier outputs from a low pass filter Additional low
frequency filtering is provided by the clamp caps The drive
resistors can be made variable or fixed at values between 0
and 300
DC output is set to approximately 4V The high frequency
response will be dependent upon external peaking at the
drive pins
Maximum output swings are achieved when the
TL H 9178 – 10