AT89C51AC3 Atmel Corporation, AT89C51AC3 Datasheet - Page 5

• Manufacturer Part Number: AT89C51AC3
• Manufacturer: Atmel Corporation

Specifications of AT89C51AC3

• Flash (kbytes): 64 Kbytes
• Max. Operating Frequency: 60 MHz
• Cpu: 8051-12C
• Max I/o Pins: 32
• Spi: 1
• Uart: 1
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 62.5
• Sram (kbytes): 2.25
• Eeprom (bytes): 2048
• Self Program Memory: API
• Operating Voltage (vcc): 3.0 to 5.5
• Timers: 4
• Isp: UART
• Watchdog: Yes

FLIP Software
Program
In-System
Programming
Boot Process
Hardware Condition
4386B–8051–03/08
FLIP is a PC software program running under Windows 9x / NT / 2K / XP and LINUX that sup-
ports all Atmel C51 Flash microcontrollers.
This free software program is available on the Atmel web site.
The ISP allows the user to program or reprogram a microcontroller’s on-chip Flash memory
through the serial line without removing it from the system and without the need of a pre-pro-
grammed application.
This section describes how to start the UART bootloader and the higher level protocol over the
serial line.
The bootloader can be activated in two ways:
•
•
The Hardware conditions (EA = 1, PSEN = 0) during the RESET# falling edge force the on-chip
bootloader execution. In this way the bootloader can be carried out whatever the user Flash
memory content.
As PSEN is an output port in normal operating mode (running user application or bootloader
code) after reset, it is recommended to release PSEN after falling edge of reset signal. The hard-
ware conditions are sampled at reset signal falling edge, thus they can be released at any time
when reset input is low.
To ensure correct microcontroller startup. The PSEN pin should not be tied to ground during
power-on.
Hardware conditions
Regular boot process
AT89C51AC3 UART Bootloader
5