5-212491-1 TE Connectivity, 5-212491-1 Datasheet - Page 3

• Manufacturer Part Number: 5-212491-1
• Manufacturer: TE Connectivity

Specifications of 5-212491-1

• Product Type: Connector
• Product Series: 109
• Shell Size: 3
• Shell Material: Steel
• Mounting Hole Diameter (mm [in]): 3.05 [.120]
• Insert Arrangement: 5C5
• Blindmate: No
• Non-magnetic: No
• Rear Grommet: No
• Power/signal/coax Combination: Yes
• Shell Plating: Zinc
• Mount Style: Mounting Holes
• Retention Clip Material: Stainless Steel
• Accepts Contact Gender: Pin
• Contact Size: 20
• Connector Style: Plug
• Density: Standard
• Government/industry Qualification: No
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Nasa Qualification: No
• Applies To: Coaxial Cable, Printed Circuit Board, Wire/Cable

Rev B
Physical shock.
Durability.
Contact retention.
Mating force.
Unm ating force.
Therm al shock.
Hum idity-tem perature cycling.
Tem perature life.
Mixed flowing gas.
NOTE
Test Description
Shall meet visual requirements, show no physical damage and shall meet requirements of
additional tests as specified in Test Sequence in Figure 2.
No discontinuities of 1 m icrosecond
or longer duration.
See Note.
See Note.
Contacts shall not dislodge.
80 ounces m axim um initial per
contact.
5 ounces m inim um initial per
contact.
See Note.
See Note.
See Note.
See Note.
ENVIRONMENTAL
Figure 1 (end)
Requirem ent
TE Spec 109-30.
TE Spec 109-26-4,
except 300 G's and 3 m illiseconds.
Subject m ated sam ples to 300 G's
half-sine shock pulses of 3
m illiseconds duration. 3 shocks in
each direction applied along 3
m utually perpendicular planes, 18
total shocks.
TE Spec 109-27.
Mate and unm ate sam ples for 500
cycles at m axim um rate of 300
cycles per hour.
Apply axial load of 15 pounds to
contacts and hold for 5 seconds.
TE Spec 109-42, Condition A.
Measure force necessary to m ate
sam ples at m axim um rate of .5 inch
per m inute.
TE Spec 109-42, Condition A.
Measure force necessary to
unm ate sam ples at m axim um rate
of .5 inch per m inute.
TE Spec 109-22.
Subject m ated sam ples to 5 cycles
between -55 and 125°C.
TE Spec 109-23-3,
Condition B.
Subject m ated sam ples to 10
cycles between 25 and 65°C at
95% RH.
TE Spec 109-43.
Subject m ated sam ples to
tem perature life at 125°C for 1000
hours.
TE Spec 109-85-2.
Subject m ated sam ples to
environm ental class II for 14 days.
Procedure
108-10045
3 of 6