194189-9 TE Connectivity, 194189-9 Datasheet - Page 5

• Manufacturer Part Number: 194189-9
• Description: Power to the Board PIN ASSY CRIMP
• Manufacturer: TE Connectivity

Specifications of 194189-9

• Product Type: Contacts
• Contact Gender: Pin (Male)
• Current Rating: 15 A
• Pitch: 3.1 mm
• Termination Style: Crimp
• Contact Plating: Silver
• Contact Material: Copper Alloy
• Housing Material: Stainless Steel
• Retention Spring Material: Stainless Steel
• Continuous Current Amperage (a): 15
• Pin Diameter (mm [in]): 3.00 [0.118]
• Pin Type: Crimp
• Hot Mate: No
• Product Name: AMPOWER
• Pin Material: Copper Alloy
• Used With: 12-14 AWG
• Contact Type: Pin
• Contact Mating Sequence: Third
• Plating Material: Silver
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Lead Free Status / Rohs Status: Details

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall each consist of a minimum of 2 samples.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1809
5 of 6