DS2187+ Maxim Integrated Products, DS2187+ Datasheet - Page 5
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
DS2187+
Manufacturer Part Number
DS2187+
Description
IC RECEIVE LINE INTERFACE 18-DIP
Manufacturer
Maxim Integrated Products
Datasheet
1.DS2187.pdf
(10 pages)
Specifications of DS2187+
Function
Receive Line Interface
Interface
T1
Number Of Circuits
1
Voltage - Supply
4.75 V ~ 5.25 V
Current - Supply
18mA
Operating Temperature
0°C ~ 70°C
Mounting Type
Through Hole
Package / Case
*
Includes
AMI / B8ZS / HDB3 Coded Signal Decoder
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Power (watts)
-
DS2187
0 CODE SUPPRESSION
The device will decode incoming B8ZS (RCLKSEL=0) or HDB3 (RCLKSEL=1) code words and replace
them with an all-0 code when ZCSEN=1. When ZCSEN=0, code words will pass through the device
without being altered. This feature can be disabled when the DS2187 is used with transceiver devices
such as the DS2180A DS2181A, DS2141A, or DS2143.
ALARM DETECTION
The extracted data is monitored for network alarm and error conditions. RCL is set when 192 consecutive
0s occur; it is cleared on the next one occurrence. AIS is set when less than three 0s have appeared at
RPOS and RNEG during the last two periods of the
signal; once set, AIS will remain high for the
RAIS
next two periods of
. AIS will return low when more than two 0s appear. BPV reports bipolar
RAIS
violations as they occur at RPOS and RNEG; B8ZS code words will not be flagged by BPV when
ZCSEN=1.
BYPASSING AND
LAYOUT CONSIDERATIONS
The DS2187 contains both precision analog and high-speed digital circuitry on the same chip. The power
supplies of these circuits (AVDD, AVSS, DVDD and DVSS) should be connected to system analog and
digital supplies. If separate system supplies do not exist, the appropriate supply pins can be tied together.
Tying the analog and digital supplies together on the DS2187 will not degrade its performance, provided
the power supply is sufficiently decoupled.
To assure optimum performance, the length of LCAP, RTIP and RRING printed circuit board traces
should be minimized and isolated from neighboring interconnect.
5 of 10