IH5051MJE/883B Maxim Integrated Products, IH5051MJE/883B Datasheet - Page 4

• Manufacturer Part Number: IH5051MJE/883B
• Description: Analog Switch Dual SPDT 16-Pin CDIP N
• Manufacturer: Maxim Integrated Products
• Type: Analog Switchr

Specifications of IH5051MJE/883B

• Package: 16CDIP N
• Maximum On Resistance: 60@±15V Ohm
• Maximum High Level Output Current: 30 mA
• Number Of Channels Per Chip: 2
• Maximum Turn-off Time: 250@±15V ns
• Maximum Turn-on Time: 500@±15V ns
• Switch Architecture: SPDT
• Power Supply Type: Dual

QUALITY ASSURANCE
Sampling and inspection procedures shall be in accordance with MIL-Prf-38535, Appendix A as specified in Mil-
Std-883.
Screening shall be in accordance with Method 5004 of Mil-Std-883. Burn-in test Method 1015:
Quality conformance inspection shall be in accordance with Method 5005 of Mil-Std-883, including Groups A, B,
C, and D inspection.
Group A inspection:
Group C and D inspections:
a. End-point electrical parameters shall be specified in Table 1.
b. Steady-state life test, Method 1005 of Mil-Std-883:
TABLE 2.
----------------------------
1. Test Condition, A, B, C, or D.
2. TA = +125 C minimum.
3. Interim and final electrical test requirements shall be specified in Table 2.
1. Tests as specified in Table 2.
2. Selected subgroups in Table 1, Method 5005 of Mil-Std-883 shall be omitted.
1. Test condition A, B, C, D.
2. TA = +125 C, minimum.
3. Test duration, 1000 hours, except as permitted by Method 1005 of Mil-Std-883.
Group C and D End-Point Electrical Parameters
**
*
PDA applies to Subgroup 1 only.
Subgroups 10 and 11, if not tested, shall be guaranteed to the limits in Table 1.
Mil-Std-883 Test Requirements
Group A Test Requirements
Interim Electric Parameters
Final Electrical Parameters
Method 5004
Method 5005
Method 5005
Method 5005
Electrical Characteristics of IH5048-51/883B
ELECTRICAL TEST REQUIREMENTS
per Method 5005, Table 1
1, 2, 3, 9, 10**, 11**
Subgroups
1*, 2, 3, 9
1
1
Page 5 of
19-0051
Rev. B
6