HR2S-332N-T30 IDEC, HR2S-332N-T30 Datasheet - Page 10

• Manufacturer Part Number: HR2S-332N-T30
• Description: 47T1447
• Manufacturer: IDEC

HR2S Safety Relay Modules
The wiring diagrams in this catalog have been tested under
actual operating conditions. The HR2S safety relay module
can be used in a safety circuit by connecting to the safety
equipment compliant to applicable standards. Consider
residual risk in the following circumstances.
a) When circuits other than described in this catalog are
•
•
•
•
•
•
•
10
10
Terminal / Coding Key
Terminal Cover
Protective Tape
For safe operation, be sure to turn the power off before
wiring or installation.
Use within the specified voltage. Do not use power
supplies that produce high ripple voltage or abnormal
voltage.
Do not use the module with an electrical load that
exceeds the switching capacity.
Do not use the module in places where inflammable
or explosive gases exist. Otherwise, fire or explosion
may occur due to a voltage arc caused by switching of
contacts.
The module is designed for use in typical machinery
manufacturing facilities. The module shall not be used
for nuclear controls, train, aeronautics, automobiles,
engines, medical, or entertainment devices or facilities.
Leave spaces of at least 5 mm from the sides of the
module when electricity of 3A or more is continuously
applied to the relay contact.
The category of the control system (hereinafter
called category) is determined based on the entire
control system. Determination of the category and
performance level for the control system (design of
the safety-related parts of the control system) must be
performed by safety experts.
used.
Maintenance Parts
Residual Risk
Safety Precautions
Name
Coding key
Terminal
(EN ISO/ISO12100-1)
HR9Z-PMC1
HR9Z-PMT1
HR9Z-PE1
Part No.
HR9Z-PMC1PN10
HR9Z-PMT1PN04
HR9Z-PE1PN05
Ordering No.
b) When the applicable standards of machine operation are
c) When the contacts of relays and contactors for connecting
•
•
•
•
•
This module is classified as overvoltage category
III. Make sure to take appropriate measures when
designing the control system.
Life of the module depends on conditions such as
switching and electrical loads. Before operation, be
sure to test under actual conditions and within the
switching capacity.
Use this module in a completely sealed control panel.
Also, leave spaces of at least more than 50 mm from
the top and the bottom of the module.
Performance may be decreased when used in an
environment where dust, cutting oil, or an organic
solvent, are present. Contact IDEC for details.
A resettable fuse, which does not require replacement
is installed in the control circuit to prevent over
current. If the switch is activated, turn off the module.
When the problem is resolved, turn on the power
again.
not observed, or when the machine is not adjusted or
maintained properly (observe a maintenance schedule).
with safety outputs are not forced guided compliant with
EN 50205.
(4 terminals and 18
coding keys)
Package Quantity
1 set
10
5
Coding keys are used to prevent
incorrect insertion of terminals.
Used to make sure that the
terminals are fully inserted.
Used to protect the AUTO/MANU
switch on the front of the module.
Remarks
(110127)