MD54-0005TR M/A-Com Technology Solutions, MD54-0005TR Datasheet - Page 3

• Manufacturer Part Number: MD54-0005TR
• Description: Up/Down Conv Mixer 800MHz 5-Pin SOT-363 T/R
• Manufacturer: M/A-Com Technology Solutions

Specifications of MD54-0005TR

• Package: 5SOT-363
• Maximum Input Frequency: 800 MHz
• Maximum Output Frequency: 1000 MHz

3
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
Commitment to produce in volume is not guaranteed.
Low Cost MMIC Mixer
800 - 1000 MHz
Recommended PCB Configuration
Layout View
Designer’s Kit MD54-005SMB
MD54-0005
Evaluation PCB & RF Connector Losses
The MD54-0005SMB Designer's Kit allows for im-
mediate evaluation of M/A-COM's MD54-0005. The
evaluation board consists of an MD54-0005,
recommended external surface mount circuitry, and
RF connectors, all mounted to a multi-layer FR-4
PCB. Other items included in the Designer's Kit are
a floppy disk (with typical performance data and a
DXF file of the recommended PCB layout) and any
additional Application Notes. The MD54-0005SMB
evaluation PCB and block diagram are illustrated
below with all functional ports labeled.
Port Reference
RF Port
LO Port
IF Port
Approximate RF Loss
0.10 dB @ 900 MHz
0.10 dB @ 900 MHz
0.05 dB @ 60 MHz
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
changes to the product(s) or information contained herein without notice.
Cross Section View
Mixer PCB
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macomtech.com for additional data sheets and product information.
The PCB dielectric between RF traces and RF ground
layers should be chosen to reduce RF discontinuities
between 50 Ω lines and package pins.
recommends an FR-4 dielectric thickness of 0.008” (0.2
mm) yielding a 50 Ω line width of 0.015” (0.38 mm). The
recommended metalization thickness is 1 oz. copper.
M/A-COM
Rev. V4