SW06GP Analog Devices Inc, SW06GP Datasheet - Page 11

• Manufacturer Part Number: SW06GP
• Manufacturer: Analog Devices Inc
• Type: Analog Switchr

Specifications of SW06GP

• Multiplexer Configuration: Quad SPST
• Number Of Inputs: 4
• Number Of Outputs: 4
• Number Of Channels: 4
• Analog Switch On Resistance: 150@±15VOhm
• Analog Switch Turn On Time: 700ns
• Analog Switch Turn Off Time: 500ns
• Package Type: PDIP
• Power Supply Requirement: Single/Dual
• Single Supply Voltage (max): 36V
• Dual Supply Voltage (typ): ±15V
• Dual Supply Voltage (max): ±18V
• Power Dissipation: 165W
• Supply Current: 9@±15VmA
• Mounting: Through Hole
• Pin Count: 16
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / Rohs Status: Not Compliant

REV. A
fastest reset times. The switch can easily handle any amount of
capacitor discharge current subject only to the maximum heat
dissipation of the package and the maximum operating junction
temperature from which repetition can be established.
SWITCHING
Switching time t
V
than t
DPDT applications. The disable input (DIS) has the same
switching times (t
Switching transients occurring at the source and drain contacts
results from ac coupling of the switching FETs gate-to-source
and gate-to-drain coupling capacitance. The switch turn ON
will cause a negative going spike to occur and the turn OFF will
cause a positive spike to occur. These spikes can be reduced by
additional capacitance loading, lower values of R
an additional switch (with its extra contact floating) to the op-
posite state connected to the spike sensitive node.
Typical Applications
ANALOG
ON
Operation from Single Positive Power Supply
to ensure a break-before-make interval for SPDT and
and temperature. In all cases, t
ON
ON
and t
and t
OFF
OFF
characteristics are plotted versus
) as the logic inputs (IN
High Off Isolation Selector Switch (Shunt-Series Switch)
OFF
is designed faster
L
, or switching
X
).
–11–
DISABLE NODE
This TTL compatible node is similar to the logic inputs IN
has an internal 2 A current source pull-up. If disable is left un-
connected, it will assume the logic “1” state, then the state of
the switches is controlled only by the logic inputs IN
POWER SUPPLIES
This product operates with power supply voltages ranging from
device parameters with 15 volt 5% power supplies. The
power supply sensitive parameters have plots to indicate effects
of supply voltages other than 15 volts.
12 to 18 volts; however, the specifications only guarantee
4-Channel Sample Hold Amplifier
SW06
X
.
X
but