SI2457-D-FS Silicon Laboratories Inc, SI2457-D-FS Datasheet - Page 24

• Manufacturer Part Number: SI2457-D-FS
• Description: IC ISOMODEM SYSTEM-SIDE 16SOIC
• Manufacturer: Silicon Laboratories Inc

Specifications of SI2457-D-FS

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Si2457/34/15/04
24
Command
Sn=x
Vn
V0
V1
Xn
X0
X1
X2
X3
X4
X5
Yn
Y0
Y1
:M
:E
:P
:R
Z
:I
Table 8. Basic AT Command Set (Command Defaults in Bold) (Continued)
Set S-register n to value x (where n and x are decimal values).
Result code type (see Table 12 on page 38).
Numeric result codes.
Verbal result codes
Call Progress Monitor (CPM)—This command controls which CPM signals are monitored
and reported to the host from the Si2457/34/15/04. (See Table 12 on page 38.)
Basic results; disable CPM—Blind dial (does not wait for dial tone). CONNECT message
does not include speed.
Extended results; disable CPM—Blind dial. CONNECT message includes speed.
Extended results and detect dial tone only—Add dial tone detection to X1 mode. Does not
blind dial.
Extended results and detect busy only—Add busy tone detection to X1 mode.
Extended results, full CPM—Full CPM enabled, CONNECT message includes speed.
Extended results—Full CPM enabled including ringback detection. Adds ringback detection
to X4 mode.
Long space disconnect—Modem hangs up after 1.5 seconds or more of continuous space
while on-line.
Disable.
Enable.
Hard Reset—This command is functionally equivalent to pulsing the RESET pin low. (See
t
Read from serial EEPROM.
Interrupt Read—This command causes the ISOmodem
interrupt register I/O Control 0 (U70). The CID, OCD, PPD, and RI bits also are cleared, and
the INT pin (INT bit in parallel mode) is deactivated on this read.
Write to serial EEPROM.
Program RAM Write—This command is used to upload firmware supplied by Silicon Labs to
the Si2457/34/15/04. The format for this command is AT:Paaaa,xxxx,yyyy,.... where aaaa is
the first address in hexadecimal and xxxx,yyyy,.... is data in hexadecimal. Only one :P com-
mand is allowed per AT command line. No other commands can be concatenated in the :P
command line. This command is only for use with special files provided by Silicon Laborato-
ries. Do not attempt to use this command for any other purpose.
User-Access Register Read—This command allows the user to read from the user-access
registers (see "6. User-Access Registers (U-Registers)" on page 44). The format is “AT:Raa”,
where:
aa = user-access address in hexadecimal.
The “AT:R” command causes all the U- registers to be displayed.
AT
in Table 6 on page 7.)
Rev. 1.3
Action
®
to report the lower 8 bits of the