G5V-2-FDDC12 Omron, G5V-2-FDDC12 Datasheet - Page 4

• Manufacturer Part Number: G5V-2-FDDC12
• Description: RELAY PC MNT DPDT
• Manufacturer: Omron
• Series: G5V-2r

Specifications of G5V-2-FDDC12

• Relay Type: General Purpose
• Contact Form: DPDT (2 Form C)
• Contact Rating (current): 2A
• Switching Voltage: 125VAC, 125VDC - Max
• Coil Type: Non Latching
• Coil Current: 41.7mA
• Coil Voltage: 12VDC
• Turn On Voltage (max): 9 VDC
• Turn Off Voltage (min): 0.6 VDC
• Features: Sealed - Fully
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Contact Material: Silver (Ag), Gold (Au)
• Operate Time: 7ms
• Release Time: 3ms
• Coil Power: 500 mW
• Coil Resistance: 288 Ohms
• Operating Temperature: -25°C ~ 65°C
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: G5V2FDDC12

Dimensions
Note: 1. All units are in millimeters unless otherwise indicated.
G5V-2, G5V-2-H1
■ Approvals
UL Recognized (File No. E41515) / CSA Certified (File No. LR31928) - - Ambient Temp. = 40°C
Note: 1. The rated values approved by each of the safety standards may be different from the performance characteristics individually defined in this catalog.
Precautions
Long-term Continuously ON Contacts
Using the Relay in a circuit where the Relay will be ON continuously
for long periods (without switching) can lead to unstable contacts
because the heat generated by the coil itself will affect the insulation,
causing a film to develop on the contact surfaces. Be sure to use a
fail-safe circuit design that provides protection against contact failure
or coil burnout.
80
G5V-2
G5V-2-H1
2. Tolerance: ±0.1
3. Orientation marks are indicated as follows:
2. In the interest of product improvement, specifications are subject to change.
Type
Low Signal Relay
DPDT
0.5
20.5 max.
20.3 typ.
Contact form
G5V-2
0.3
3 to 48 VDC
3 to 48 VDC
10.1 max.
9.9 typ.
7.62
Coil rating
3.5
0.5
11.5 max.
11.4 typ.
Terminal Arrangement/
Internal Connections
(Bottom View)
Relay Handling
When washing the product after soldering the Relay to a PCB, use a
water-based solvent or alcohol-based solvent, and keep the solvent
temperature to less than 40°C. Do not put the Relay in a cold clean-
ing bath immediately after soldering.
16
1
0.6 A at 125 VAC (General Use)
0.6 A at 110 VDC (Resistive)
2 A at 30 VDC (Resistive)
0.5 A at 125 VAC (General Use)
0.2 A at 110 VDC (Resistive)
1 A at 24 VDC (Resistive)
13
4
11
6
9
8
(1.3)
Eight, 1-dia. holes
Contact ratings
7.62
Tolerance: ±0.1
Mounting Holes
(Bottom View)
5.08 5.08
7.62
(1.3)
(1.2)