LV8548M-TLM-H ON Semiconductor, LV8548M-TLM-H Datasheet - Page 6

• Manufacturer Part Number: LV8548M-TLM-H
• Description: 2-CH BRUSH MOTOR DRIVER
• Manufacturer: ON Semiconductor

Specifications of LV8548M-TLM-H

• Motor Type: Stepper
• No. Of Outputs: 2
• Output Current: 1A
• Supply Voltage Range: 4V To 16V
• No. Of Pins: 10
• Operating Temperature Range: -30°C To +85°C
• Svhc: No SVHC (20-Jun-2011)
• Rohs Compliant: Yes
• Lead Free Status / Rohs Status: Supplier Unconfirmed

3. Example of applied circuit when connecting it in parallel
The use likened to H bridge 1ch is shown possible in the figure below by connecting IN1 with IN3, IN2 with IN4,
OUT1 with OUT3, OUT2, and OUT4. (I O max=2.0A, Upper and lower total R ON =0.5Ω)
* Bypass capacitor (C1) connected between V CC -GND of all examples of applied circuit recommends the electric field
capacitor of 0.1μA to 10μA.
Confirm there is no problem in operation in the state of the motor load including the temperature property about the
value of the capacitor.
Mount the position where the capacitor is mounted on nearest IC.
This catalog provides information as of July, 2010. Specifications and information herein are subject
to change without notice.
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
C1
+
Logic input
LV8548M
M
LV8548M
PS No.A1802-6/6