5314* 3M Interconnect Solutions, 5314* Datasheet

no-image

5314*

Manufacturer Part Number
5314*
Description
Manufacturer
3M Interconnect Solutions
Datasheet

Specifications of 5314*

Lead Free Status / Rohs Status
Supplier Unconfirmed
Motor Lead Pigtail Splice
for 1000 volts (or less) cables with
one-hole lugs
Instructions
Kit Contents (kit contains 3 splices):
3 Lug Covers
3 Tubes Silicone Grease
3 Mastic Sealing Strips
Kit Selection Table
* Lug cover I.D. - use when calculating kit sizing for a connection of more than two conductors (e.g. 3-way, 4-way, etc. Use of one-hole stacking
Technical Information:
For use on Non-Shielded Cables 1000 Volts
(or less) with one-hole lugs.
Cable Size Range:
Feeder: 14 AWG-4 AWG
Motor Lead: 16 AWG-4 AWG
Copper Conductors
lugs is recommended.)
Working around energized high-voltage systems may
cause serious injury or death. Installation should be
performed by personnel familiar with good safety
practice in handling high-voltage electrical equipment.
De-energize and ground all electrical systems before
installing product.
Number
CAUTION
5300
5301
Kit
Feeder
(2,5 - 4)
(6 - 16)
14 - 10
10 - 4
Cable Size Range
AWG (mm
Motor Lead
(1,5 - 2,5)
(4 - 16)
16 -12
12 - 4
2
)
Cable Insulation
O.D. Range
0.12 - 0.21
0.17 - 0.36
in. (mm)
Table 1
(3 - 5)
(4 - 9)
Pigtail Splice Kits
3M
78-8126-0998-6-A
Lug Cover*
in. (mm)
for 1000 Volts (or less)
0.45
0.70
(11)
(18)
I.D.
5300, 5301
Motor Lead
Bolt Length
in. (mm)
Maximum
(10)
(13)
3/8
1/2

5314* Summary of contents

Page 1

Motor Lead Pigtail Splice for 1000 volts (or less) cables with one-hole lugs Instructions Kit Contents (kit contains 3 splices): 3 Lug Covers 3 Tubes Silicone Grease 3 Mastic Sealing Strips Kit Selection Table Kit Cable Size Range Number AWG ...

Page 2

A. Prepare Cables According to Standard Procedures 1. Check to be sure cable sizes fit within the kit range as shown in Table 1. 2. Remove cable insulation for length recommended by terminal lug manufacturer information is available, ...

Page 3

Overwrap the mastic with wraps of vinyl tape. 4. Install lug cover. Note: The kit contains a small tube of silicone grease. Use it to lightly lubricate the mastic-vinyl wrap. This will aid in installing the ...

Page 4

... Appendix A Splice Removal 1. Remove Vinyl Tape from end of Lug Cover. (Avoid use of knife or other sharp tools that could damage cables.) 2. Slide Lug Cover off of lugged or split-bolt connection splice was sealed for moisture resistance: Remove Mastic and Vinyl Tape Seal from cables. ...