CC-720 Panduit Corp, CC-720 Datasheet

no-image

CC-720

Manufacturer Part Number
CC-720
Description
Manufacturer
Panduit Corp
Datasheet
1.CC-720.pdf (2 pages)

Specifications of CC-720

Lead Free Status / Rohs Status
RoHS Not Applicable
TOOLS REQUIRED
5/32” Hex Wrench
3/16” Hex Wrench
INSTALLATION
1.
2.
3.
4.
5.
7.
8.
Copyright © 2002
All Rights Reserved
M
mOL
With Panduit Logo side of tool down, remove the left two nuts securing the handle to the head
assembly.
Drive out the L.H. bolt, and replace (from logo side) with the L.H. Stub Bolt (Item #11). Put on a
3/8” Nut (Item #13) and tighten by hand.
With Panduit logo side up, attach the Pawl Stud (Item #9). Insert Roll Pin (Item #10) on the tool
and tap pin in with hammer until it stops. From the other side, screw the ¼-20 Cap Screw (Item
#8) into the pawl stud.
Insert a Spacer (Item #5) over Pawl Stud. Apply small amount of grease to top side.
Attach hook end of Spring (Item #12) to Pawl (Item #4), insert pawl over pawl stud, then attach
other end of spring over Roll Pin (Item #10). Note: Refer to drawing for proper orientation of
pawl.
Apply small amount of grease to topside of pawl and pawl stud. Place another Spacer (Item #5)
over pawl stud, on top of pawl.
Drive out the center bolt and reinsert bolt in from opposite side to maintain bolt hole alignment.
Caution:
Moly Grease
Moving the tool at this time will disrupt the alignment of the parts around the center bolt.
(Refer to the figure above for parts included in the kit.)
9/16" and 1/2" Box or Open End Wrench
Hammer
CC-720
CONTROLLED CYCLE MECHANISM
1
PA23999A01
7/2002

CC-720 Summary of contents

Page 1

... Drive out the center bolt and reinsert bolt in from opposite side to maintain bolt hole alignment. Caution: Moving the tool at this time will disrupt the alignment of the parts around the center bolt. Copyright © 2002 All Rights Reserved CC-720 CONTROLLED CYCLE MECHANISM 9/16" and 1/2" Box or Open End Wrench Hammer 1 ...

Page 2

Apply small amount of grease to bottom side of Spacer (Item #5) and place over the center bolt hole. 10. Apply grease to center pivot hole of the Ratchet Plate (Item #6). Assemble the slot end of ratchet plate ...