K350QVG-V2-F KENTEC ELECTRONICS, K350QVG-V2-F Datasheet - Page 12

• Manufacturer Part Number: K350QVG-V2-F
• Description: LCD MODULE, 3.5", 320X240, TOUCH SCREEN
• Manufacturer: KENTEC ELECTRONICS

Specifications of K350QVG-V2-F

• Backlighting Color: White
• Lcd Display Type: TFT
• Pixel Size (h X W): 0.219mm X 0.219mm
• Display Mode: Transmissive
• Interface Type: Parallel
• Viewing Area (h X W): 72.88mm X 55.36mm
• Rohs Compliant: Yes

10.2 Cautions for installing and assemabling if the module has Touch Panel
12. Absolutely do not modify the zebra rubber strip (conductive rubber) or heat seal connector
9. Do not alter, modify or change the the shape of the tab on the metal frame.
10. Do not make extra holes on the printed circuit board, modify its shape or change the positions of
11. Do not damage or modify the pattern writing on the printed circuit board.
13. Except for soldering the interface, do not make any alterations or modifications with a soldering iron.
14. Do not drop, bend or twist LCM.
6. Install the LCD Module by using the mounting holes. When mounting the LCD module make sure it is
free of twisting, warping and distortion. In particular, do not forcibly pull or bend the I/O cable or the
backlight cable.
8. To prevent destruction of the elements by static electricity, be careful to maintain an optimum work
7. Don’ t disassemble the LCM.
1. Use a buffer material (Gasket) between the touch panel and Front-case to protect damage and wrong
operating. The dimension of the buffer material’ s edge between the TP V.A. edge is Min. 0.3mm.
2. We recommend to design a case that it can’ t over the boundary of the active area Max. 0.5mm in order
to prevent an operation at outside of the active area which can’ t guarantee the specified durability,
environment.
water droplets, moisture condensation or a current flow in a high-humidity environment.
components to be attached.
-
-
-
-
Be sure to ground the body when handling the LCD modules.
Tools required for assembling, such as soldering irons, must be properly grounded.
To reduce the amount of static electricity generated, do not conduct assembling and other work
under dry conditions.
The LCD module is coated with a film to protect the display surface. Exercise care when peeling
off this protective film since static electricity may be generated.
FS-K350QVG-V2-F
15/Jul/2010
PAGE 11 OF 19