HTA-300-S LEM USA Inc, HTA-300-S Datasheet - Page 3

• Manufacturer Part Number: HTA-300-S
• Description: SENSOR CURR 300A -/+15V MOD
• Manufacturer: LEM USA Inc
• Series: HTAr

Specifications of HTA-300-S

• Current - Sensing: 300A
• Accuracy: ±1%
• Sensitivity: -
• Sensor Type: Open Loop Hall Effect
• Voltage - Supply: -15 V ~ 15 V
• Output: ±4V
• Frequency: 50kHz
• Polarization: Bidirectional
• Operating Temperature: -25°C ~ 85°C
• Package / Case: Module
• Other names: Q2723012

Dimensions HTA 100 .. 1000-S
Mechanical characteristics
●
●
●
090430/6
Dimensions HTA 100..1000-S
General tolerance
Mechanical characteristics
Primary through-hole
Connection of secondary
•
•
•
Remarks
•
•
•
080516/5
Bottom view
Front view
General tolerance
Primary through-hole
Connection of secondary
V
Temperature of the primary conductor should not exceed
90°C.
This is a standard model. For different versions (supply
voltages, secondary connections, unidirectional measure-
ments, operating temperatures, etc.) please contact us.
OUT
is positive when I
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
P
flows in the direction of the arrow.
± 0.5 mm
Ø 32 mm
Molex 5045-04A
(in mm. 1 mm = 0.0394 inch)
± 0.5 mm
Ø 32 mm
Molex 5045-04A
(in mm. 1 mm = 0.0394 inch)
Remarks
●
●
●
Safety
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the manufacturer's operating instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
V
Temperature of the primary conductor should not exceed
90°C.
This is a standard model. For different versions (supply
voltages, secondary connections, unidirectional
measurements, operating temperatures, etc.,) please
contact us.
OUT
is positive when I
Secondary terminals
Terminal 1
Terminal 2
Terminal 3
Terminal 4
Secondary terminals
Terminal 1
Terminal 2
Terminal 3
Terminal 4
P
flows in the direction of the arrow.
: Supply voltage + 15 V
: Supply voltage - 15 V
: Output
: 0V
: supply voltage + 15 V
: supply voltage - 15 V
: output
: 0V
www.lem.com
www.lem.com
Left view
Page 3/3
Page 2/2