EVQPLHA15 Panasonic, EVQPLHA15 Datasheet - Page 6

• Manufacturer Part Number: EVQPLHA15
• Description: LIGHT TOUCH SWITCH SMD SUPER THIN TYPE
• Manufacturer: Panasonic

Classification
Part Name
6. Prohibitions and precaution for handling
6.1 Reflow soldering condition
6.2 Design instructions
6.3 Notes
1) Two times max. with directing the switch mounting side of P.W.B up.
2) Re-soldering by soldering iron shall be allowed under 350℃ max. 3 sec. max. 1 time only
1) Please refer to the land pattern plan Panasonic recommends on the 2nd page.
2) Design key top as fig-1. Design inclination of key top 4 deg. max. as fig-2.
1) Please be cautions not to give excessive static load or shock to switches.
2) Please be careful not to pile up P.W.B. after switches were soldered.
3) Preservation under high temperature and high humidity or corrosive gas should be avoided
4) Avoid pressing the film portion of the product with sharp-edged object.
5) Avoid the use of the switch under pushed ON condition is continued for a long time.
6) There is a possibility the flux from solder paste infiltrates into the body if plenty of
Also please avoid putting additional land by the switch on the P.W.B.
Tolerance between switch and key top is within 0.3mm.
especially. When you need to preserve for a long period, do not open the carton.
solder paste was applied by switch on the P.W.B.
So we recommend to use our proposed land design in order to prevent above problem.
(Recommended operation condition)
and the tip of iron must not touch to terminals.
Soldering iron for re-soldering have to be 60W max.
LIGHT TOUCH SWITCH
fig-1
REFERENCE SPECIFICATION
Panasonic Electronic Devices Co., Ltd.
Part No.
EVQPLHA15
fig-2
Issue No.
20090988
6/8