SI2400-KS Silicon Laboratories Inc, SI2400-KS Datasheet - Page 51

• Manufacturer Part Number: SI2400-KS
• Description: IC ISOMODEM SYSTEM-SIDE 16SOIC
• Manufacturer: Silicon Laboratories Inc
• Type: Integrated Global DAAr

Specifications of SI2400-KS

• Package / Case: 16-SOIC (3.9mm Width)
• Data Format: V.21, V.22, V.23, Bell 103, Bell 212A
• Baud Rates: 2.4k
• Interface: UART
• Voltage - Supply: 3 V ~ 5.25 V
• Mounting Type: Surface Mount
• Product: Modem Chip
• Supply Voltage (min): 3 V
• Supply Current: 21 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With: 336-1166 - BOARD EVAL FOR SI2400 ISOMODEM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 336-1093

S0C (MF2). Modem Functions 2
Reset settings = 0000_0000
Name
Type
Bit
6:5
Bit
7
4
3
2
1
0
Reserved
CDE
R/W
D7
Name
CIDM
MCH
CDE
MLB
BDL
9BF
D6
CIDM
Carrier Detect Enable.
0 = Disable.
1 = Enable GPI02 as an active low carrier detect pin (must also set SE2[3:2]
[GPIO2] = 01
Caller ID Monitor.
00 = Caller ID monitor disabled (Normal caller ID operation).
01 = Caller ID monitor enabled. Si2400 must detect channel seizure signal followed by
marks in order to report caller ID data.
10 = Caller ID monitor enabled. Si2400 must detect a DTMF A or D followed by marks in
order to report caller ID data.
11 = Caller ID monitor enabled. Si2400 must only detect marks in order to report caller ID
data.
Read returns zero.
Ninth Bit Function.
Only valid if the ninth bit escape is set S15[0] (NBE).
0 = Ninth bit equivalent to ALERT.
1 = Ninth bit equivalent to HDLC EOFR.
Blind Dialing.
0 = Blind dialing disabled.
1 = Enables blind dialing after dial timeout register S02 (CW) expires.
Modem Loopback.
0 = Not swapped.
1 = Swaps frequency bands in modem algorithm to do a loopback in a test mode.
Miscellaneous Characters.
0 = Disables “.” and “/” character echoing.
1 = Enables “.” and “/” character echoing to indicate tone on and tone off for !7 operation.
R/W
b
(0x00)
D5
b
).
D4
R/W
9BF
D3
Rev. 1.3
BDL
R/W
D2
Function
MLB
R/W
D1
MCH
R/W
D0
Si2400
51