DCN1-2C Omron, DCN1-2C Datasheet - Page 94

• Manufacturer Part Number: DCN1-2C
• Description: DEVICENET T-TAP 1 DROP
• Manufacturer: Omron

Specifications of DCN1-2C

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: DCN12C

Wiring Methods
1,2,3...
Note
■
■
Attaching the Cable
Insert the cable to this point.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
Align the cable labels and cable colors and insert the cable.
Confirm that the cable is inserted all the way to the back. (The cover is semi-
transparent.)
The connector is pressure-welded by using the DWT-A01 Pliers.
1. As shown below, align the center (see arrows) of the connector cover with
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
(1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
(3) Set the connector in the correct orientation.
the center of the pressure-welding block on the DWT-A01 Pliers.
place.
Pliers
welding block.
OK
NG
Insert the cable to this point.
Connector cover
NG
NG
Section 2-4
73