CV500-COV04 Omron, CV500-COV04 Datasheet - Page 74
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
CV500-COV04
Manufacturer Part Number
CV500-COV04
Description
CONNECTOR COVER
Manufacturer
Omron
Datasheet
1.CV500-COV01.pdf
(182 pages)
Specifications of CV500-COV04
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
CV500COV04
- Current page: 74 of 182
- Download datasheet (2Mb)
Wiring I/O Units
3-5
Wiring I/O Units
!
WARNING
!
Caution
Note
Connect the I/O Devices to the I/O Units using AWG 22 lead wire (cross-section-
al area: 0.3 mm
(cross-sectional area: 0.3 to 0.75 mm
minals have screws with 3.5-mm diameter heads and self-raising pressure
plates. Connect the lead wires to the terminals as shown. Tighten the screws to a
torque of 0.8 N m.
Use crimp terminals for wiring. Do not connect bare stranded wires directly to
terminal blocks. Use M3.5 screws for tightening crimp terminals.
Always attach crimp terminals to the wires to ensure proper connection.
Connecting loose wires can cause fires.
Abide by the following precautions when wiring the I/O Units. Failure to abide by
these precautions my cause faulty operation or damage to the Unit.
7 mm max.
1. Putting I/O lines and high-tension lines or power lines in the same duct or
2. Use reinforced insulation or double insulation on the DC power supply con-
3. Use separate power supplies for Relay Output Units and DC I/O Units when
Be sure that no wire clippings or other foreign materials enter the Units when
wiring.
Check and recheck all wiring before supplying power to the system.
Check and recheck terminal block before mounting them to the Unit.
conduit may cause the I/O lines to be affected by noise. This may cause a
malfunction in the Unit or may damage the Unit or I/O devices.
nected to DC I/O Units when complying with EC directives (low voltage).
complying with EC directives (low voltage).
A
Tightening torque: 0.8 N m
2
) for 19-terminal terminal blocks and AWG 22 to 18 lead wire
M3.5 screw
2
) for 10-terminal terminal blocks. The ter-
Terminal block
20-terminal
Terminal block
38-terminal
Terminal block
7 mm max.
16.5 mm max.
25 mm max.
Section 3-5
A
61