MCP23S08-E/SO Microchip Technology, MCP23S08-E/SO Datasheet - Page 10

• Manufacturer Part Number: MCP23S08-E/SO
• Description: IC I/O EXPANDER SPI 8B 18SOIC
• Manufacturer: Microchip Technology

Specifications of MCP23S08-E/SO

• Package / Case: 18-SOIC (7.5mm Width)
• Interface: SPI
• Number Of I /o: 8
• Interrupt Output: Yes
• Frequency - Clock: 10MHz
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Includes: POR
• Logic Family: MCP23S08
• Propagation Delay Time: 50 ns
• Operating Supply Voltage: 1.8 V to 5.5 V
• Power Dissipation: 700 mW
• Operating Temperature Range: - 40 C to + 125 C
• Input Voltage: 1.8 V to 5.5 V
• Logic Type: I/O Expander
• Maximum Clock Frequency: 10 MHz
• Maximum Operating Frequency: 1.7 MHz
• Mounting Style: SMD/SMT
• Output Current: 25 mA
• Output Voltage: 1.8 V to 4.5 V
• Chip Configuration: 8 Bit
• Bus Frequency: 10MHz
• Ic Interface Type: Serial, SPI
• No. Of I/o's: 8
• Supply Voltage Range: 1.8V To 5.5V
• Digital Ic Case Style: SOIC
• No. Of Pins: 18
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Delay Time: 50ns
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: GPIODM-KPLCD - BOARD DEMO LCD GPIO EXP KEYPAD
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

MCP23008/MCP23S08
1.6.3
The GPINTEN register controls the interrupt-on-
change feature for each pin.
If a bit is set, the corresponding pin is enabled for
interrupt-on-change. The DEFVAL and INTCON
registers must also be configured if any pins are
enabled for interrupt-on-change.
REGISTER 1-3:
DS21919B-page 10
bit 7-0
INTERRUPT-ON-CHANGE
CONTROL (GPINTEN) REGISTER
GPINTEN – INTERRUPT-ON-CHANGE PINS (ADDR 0x02)
GPINT7:GPINT0: General purpose I/O interrupt-on-change bits <7:0>.
1 = Enable GPIO input pin for interrupt-on-change event.
0 = Disable GPIO input pin for interrupt-on-change event.
Refer to INTCON and GPINTEN.
bit 7
Legend:
R = Readable bit
- n = Value at POR
GPINT7
R/W-0
GPINT6
R/W-0
GPINT5
R/W-0
W = Writable bit
‘1’ = Bit is set
GPINT4
R/W-0
GPINT3
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
R/W-0
GPINT2
R/W-0
© 2005 Microchip Technology Inc.
x = Bit is unknown
GPINT1
R/W-0
GPINT0
R/W-0
bit 0