WLNG-EK-DP551 Quatech, WLNG-EK-DP551 Datasheet - Page 58
![no-image](/images/no-image-200.jpg)
WLNG-EK-DP551
Manufacturer Part Number
WLNG-EK-DP551
Description
WiFi / 802.11 Modules & Development Tools AIRBORNE EVAL KIT EMBEDDED MODULES
Manufacturer
Quatech
Series
Airborne™r
Type
Transceiver, 802.11 b/gr
Datasheets
1.WLNG-AN-DP551.pdf
(2 pages)
2.WLNG-EK-DP551.pdf
(8 pages)
3.WLNG-EK-DP551.pdf
(62 pages)
Specifications of WLNG-EK-DP551
Mfg Application Notes
Transition to DP550 Devices AppNote
Frequency
2.4GHz ~ 2.4835GHz
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
Airborne Modules
58
LED Configuration
LED Configuration
Populated BT1 with 4 x
configured for network
TCP/IP connection has
AA cells and turned on
been established with
SW1 and D3 does not
SW1 and D3 does not
RF_ACT# or POST do
Plugged in the power
supply and turned on
Authenticated with a
Power is applied but
the Airborne Device
after 10-12 seconds
Device Server has
wireless network
communication
Server Module
Device Server
Table 52 - Indicator LED Debug Answers
not turn ON
Airborne Enterprise EVB Users Guide
turn ON
turn ON
Issue
State
Description
When the RF_LINK LED is on the Airborne Device
Server module is associated to a wireless network. If
DHCP is enabled the module will request an IP
address, subnet, gateway and DNS server addresses.
The WLN_CFG LED ON indicates the Airborne Device
Server module has installed a valid IP address and is
available for network communication.
It may take several seconds for the WLN_CFG LED to
turn ON after the RF_LINK LED is ON, this delay is due
to the DHCP lease process.
If static IP addressing is being used the WLN_CFG LED
will turn ON after network services are available on the
module. This will be a few seconds after POST has
turned ON.
The COMM LED turning ON indicates that a TCP/IP
connection has been established between the Device
Server and a network device. This connection could be
a web interface, CLI interface or a data tunnel
connection.
The COMM LED will turn ON whether the TCP/IP
connection has been initiated by the Device Server or
from the network. If initiated from the Device Server
this indicates a successful connection with the target
Server has been made.
Description
Check the outlet plugged into is powered. Try a second
outlet.
Check the Airborne power supply is connected
correctly, reseat the power cable to the power brick.
Check that JP1 is configured to use the external power
supply.
Check that JP1 is configured to use batteries.
Make sure D2 is not ON. If D2 is ON replace the
batteries.
Make sure the Device Server Module (Ref Figure 1) is
attached to the Evaluation board. Confirm the module
is seated correctly by pushing lightly down on the units
using the edges of the device. Avoid pushing on the
label.
Quatech, Inc.
100-8082-110