4A 3M, 4A Datasheet - Page 3

• Manufacturer Part Number: 4A
• Description: Chemicals SCOTCHCAST 3.2oz
• Manufacturer: 3M

Specifications of 4A

• Product: Adhesives
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 05400743165

Installation Techniques
Precautions
First Aid Information
If there is any evidence of moisture in the cable, it must be removed and the substrate dried before applying the resin.
Causes burns. May cause allergic skin reaction. Inhalation of vapors may cause respiratory tract irritation and
central nervous system depression.
Contains a chemical(s) which can cause cancer and birth defects or other reproductive harm.
NOTE: 3M™ Scotchcast™ Electrical Insulating Resin 4 is not impaired by
Thoroughly clean and dry the surface of the substrate, to which the resin will be
bonded. In the case of synthetic cable jackets, the resin must be poured immediately
after the surface is prepared to help create a bond.
Remove the closed mixing bag by tearing the protective envelope.
Premix the darker side of the resin to a smooth consistency, by squeezing, before
breaking the barrier. Firmly grasp each flat side of the bag near the center barrier,
while pulling the sides of the barrier apart and rolling the sides of thumbs through the
barrier. Break the barrier all the way across to the side seals.
Alternately squeeze each end of the bag forcing the resin back and forth. Strip the
resin from the corners of the bag. Mix until the color is uniform (30 to 40 squeezes).
Approximately one to two minutes.
Clip off a corner of the closed mixing pouch and pour into the mold fill spout,
maintaining a half-inch head. For the 4D-NZ delivery, break the second seal and pour
through the nozzle.
Typical Cure Times:
Do not get in eyes, on skin, or on clothing. Wear suitable protective clothing, gloves,
and eye and face protection. Do not ingest. When using, do not eat, drink or smoke.
Avoid breathing vapors. Use only in well ventilated areas. Wash thoroughly after
handling. For industrial or professional use only.
Eye Contact: Immediately flush eyes with large amounts of water for at least 15
minutes. Get immediate medical attention. Skin Contact: Remove contaminated
clothing and shoes. Immediately flush skin with large amounts of water for at least
15 minutes. Get immediate medical attention. Wash contaminated clothing and clean
shoes before reuse. Inhalation: Remove person to fresh air. If signs/symptoms
develop, get medical attention. If Swallowed: Do not induce vomiting. Give person
two glasses of water. Never give anything by mouth to an unconscious person. Get
immediate medical attention.
Refer to Material Safety Data sheet for additional precautionary information.
freezing; however, it should be warmed to at least 60°F (16°C) before
being mixed or poured.
Caution
3 of 4
Danger
70°F (21°C)
50°F (10°C)
Temp
1 to 2 hours
4 to 8 hours
Cure Time