HEDS-5500-A05 Avago Technologies US Inc., HEDS-5500-A05 Datasheet - Page 10

• Manufacturer Part Number: HEDS-5500-A05
• Description: Optical Encoder, Two Ch Quadrature, TTL Compatible, PCB Mount
• Manufacturer: Avago Technologies US Inc.

Specifications of HEDS-5500-A05

• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

Encoder Mounting and Assembly
1. For HEDS-5500 and 5600: Mount encoder base plate onto
motor. Tighten screws. Go on to step 2.
1a. For HEDS-5540, 5640 and HEDM-5500, 5600: Slip
alignment tool onto motor shaft. With alignment tool in
place, mount encoder baseplate onto motor as shown above.
Tighten screws. Remove alignment tool.
3a. Push the hex wrench into the body of the encoder to
ensure that it is properly seated into the code wheel hub set
screws. Then apply a downward force on the end of the hex
wrench. This sets the code wheel gap by levering the code
wheel hub to its upper position.
3b. While continuing to apply a downward force, rotate the
hex wrench in the clockwise direction until the hub set
screw is tight against the motor shaft (The recommended
torque to tighten the setscrew is 15-18 ozf.inch). The hub
set screw attaches the code wheel to the motor's shaft.
10
2. Snap encoder body onto base plate locking all 4 snaps.
3c. Remove the hex wrench by pulling it straight out of the
encoder body.
4. Use the center screwdriver slot, or either of the two side
slots, to rotate the encoder cap dot clockwise from the one
dot position to the two dot position. Do not rotate the
encoder cap counterclockwise beyond the one dot position.
The encoder is ready for use!