MCP2515-I/ST Microchip Technology Inc., MCP2515-I/ST Datasheet - Page 50

• Manufacturer Part Number: MCP2515-I/ST
• Description: CAN CONTROLLER WITH SPI INTERFACE
• Manufacturer: Microchip Technology Inc.
• Type: Programmable Peripheral Interfacer

Specifications of MCP2515-I/ST

• Package Type: 20-Pin TSSOP
• Voltage, Supply: 2.7-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

MCP2515
7.6.2
The REC has reached the MCU warning limit of 96.
7.6.3
The TEC has reached the MCU warning limit of 96.
7.6.4
The REC has exceeded the error-passive limit of 127
and the device has gone to error-passive state.
7.6.5
The TEC has exceeded the error- passive limit of 127
and the device has gone to error- passive state.
REGISTER 7-1:
DS21801D-page 50
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
RECEIVER WARNING
TRANSMITTER WARNING
RECEIVER ERROR-PASSIVE
TRANSMITTER ERROR-PASSIVE
CANINTE – INTERRUPT ENABLE
(ADDRESS: 2Bh)
bit 7
MERRE: Message Error Interrupt Enable bit
1 = Interrupt on error during message reception or transmission
0 = Disabled
WAKIE: Wakeup Interrupt Enable bit
1 = Interrupt on CAN bus activity
0 = Disabled
ERRIE: Error Interrupt Enable bit (multiple sources in EFLG register)
1 = Interrupt on EFLG error condition change
0 = Disabled
TX2IE: Transmit Buffer 2 Empty Interrupt Enable bit
1 = Interrupt on TXB2 becoming empty
0 = Disabled
TX1IE: Transmit Buffer 1 Empty Interrupt Enable bit
1 = Interrupt on TXB1 becoming empty
0 = Disabled
TX0IE: Transmit Buffer 0 Empty Interrupt Enable bit
1 = Interrupt on TXB0 becoming empty
0 = Disabled
RX1IE: Receive Buffer 1 Full Interrupt Enable bit
1 = Interrupt when message received in RXB1
0 = Disabled
RX0IE: Receive Buffer 0 Full Interrupt Enable bit
1 = Interrupt when message received in RXB0
0 = Disabled
Legend:
R = Readable bit
-n = Value at POR
MERRE
R/W-0
WAKIE
R/W-0
ERRIE
R/W-0
Preliminary
W = Writable bit
‘1’ = Bit is set
R/W-0
TX2IE
7.6.6
The TEC has exceeded 255 and the device has gone
to bus-off state.
7.7
Interrupts are directly associated with one or more sta-
tus flags in the CANINTF register. Interrupts are pend-
ing as long as one of the flags is set. Once an interrupt
flag is set by the device, the flag can not be reset by the
MCU until the interrupt condition is removed.
Interrupt Acknowledge
R/W-0
TX1IE
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
BUS-OFF
R/W-0
TX0IE
© 2005 Microchip Technology Inc.
x = Bit is unknown
RX1IE
R/W-0
RX0IE
R/W-0
bit 0