MCP2003-E/MD Microchip Technology, MCP2003-E/MD Datasheet - Page 2

• Manufacturer Part Number: MCP2003-E/MD
• Description: TXRX LIN BUS BIDIRECT 8DFN
• Manufacturer: Microchip Technology
• Type: Transceiverr

Specifications of MCP2003-E/MD

• Package / Case: 8-DFN
• Number Of Drivers/receivers: 1/1
• Protocol: LIN
• Voltage - Supply: 6 V ~ 27 V
• Mounting Type: Surface Mount
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Operating Supply Voltage: 6 V to 27 V
• Supply Current: 90 uA
• Output Voltage: 400mV
• Output Current: 200mA
• Supply Voltage Range: 6V To 27V
• Baud Rate: 20Kbaud
• Digital Ic Case Style: DFN
• No. Of Pins: 8
• Peak Reflow Compatible (260 C): Yes
• Rohs Compliant: Yes
• Leaded Process Compatible: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

TB3067
To prevent an undesired wake-up scenario in a LIN bus
loss situation, the Power-Down mode has to be entered
via the Transmitter-Off mode observing specific timings
and the switching sequence outlined below (“Forced
Power-Down mode”).
The following state machine diagram shows the paths
to enter the MCP2003 Power-Down mode from
Operation mode or Transmitter-Off mode.
FIGURE 2:
The Forced Power-Down mode sequence is used to
enter Power-Down mode without activating the
transceiver to reduce the current consumption of the
transceiver. After the device is in Ready mode, this path
could be selected by holding TXD and CS in low state
for t
before resetting CS to ‘0’. This results in all functionality
being disabled in the transceiver until CS goes high or
a falling edge on LIN bus had been detected.
DS93067A-page 2
Note: * TXD = 0 before raising CS to ‘1’.
VREN OFF
TX2CS
RX OFF
TX OFF
POR
,
and then setting CS to ‘1’ for t
on LIN or CS = 1
Falling Edge
Entering MCP2003 Power-Down Mode From Operation Mode or Transmitter-Off Mode.
VBAT > 5.5V
Power-Down
VREN OFF
RX OFF
TX OFF
CS = 1 and TXD = 0*
Mode
CSactive
TOFF Mode
Ready Mode
VREN ON
VREN ON
TX OFF
RX ON
TX OFF
RX ON
CS = 0
To enter Power-Down mode from Ready mode, the
MCP2003 has two different paths:
• Passing through Transmitter-Off mode (T
• Passing through Operating mode, which is shown
which is shown in red in
in blue in
CS = 1 and TXD = 1
(Thermal or Timer)
and No Fault
CS = 1 and TXD = 1
CS = 0
Fault
Figure 2
© 2011 Microchip Technology Inc.
Figure 2
Operation
VREN ON
Mode
RX ON
TX ON
OFF
),