MCP73833-AMI/UN Microchip Technology Inc., MCP73833-AMI/UN Datasheet - Page 14

• Manufacturer Part Number: MCP73833-AMI/UN
• Description: Controller, Chg Mgnt, 1A Li-Ion/Li-Poly, PG* pin, MSOP-10
• Manufacturer: Microchip Technology Inc.

Specifications of MCP73833-AMI/UN

• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

MCP73833/4
5.2.2
The power good (PG) option is a pseudo open-drain
output. The PG output can sink current, but not source
current. However, there is a diode path back to the
input, and as such, the PG output should only be pulled
up to the input. The PG output is low whenever the
input to the MCP73833 is above the UVLO threshold
and greater than the battery voltage. If the supply volt-
age is above the UVLO, but below V
the MCP73833 will pulse the PG output as the device
determines if a battery is present.
5.2.3
The timer enable (TE) input option is used to enable or
disable the internal timer. A low signal on this pin
enables the internal timer and a high signal disables
the internal timer. The TE input can be used to disable
the timer when the charger is supplying current to
charge the battery and power the system load. The TE
input is compatible with 1.8V logic.
DS22005A-page 14
POWER GOOD (PG) OPTION
TIMER ENABLE (TE) OPTION
REG
(Typ)+0.3V,
5.2.4
The current regulation set input pin (PROG) can be
used to terminate a charge at any time during the
charge cycle, as well as to initiate a charge cycle or
initiate a recharge cycle.
Placing a programming resistor from the PROG input to
V
float or by applying a logic-high input signal, disables
the device and terminates a charge cycle. When
disabled, the device’s supply current is reduced to
100 µA, typically.
SS
enables the device. Allowing the PROG input to
DEVICE DISABLE (PROG)
© 2006 Microchip Technology Inc.